Owners Manual

ManualsBrandsMr Steam ManualsPlumbingIButler Max Linear Steam Generator Control Kit / Package

STEP 7

Apply a bead of silicone around the perimeter of the

 xture (Figure 6) as required to create a moisture seal

between the  xture and the steam room ceiling.

STEP 6

Squeeze the retention springs on the back of the  xture

and  t them into the junction box (Figure 5).

Insert the  xture into the junction box and af x it to the

ceiling, being careful not to pinch the pigtail/control

cable. Press  rmly around edges of the  xture to ensure

adhesion to ceiling.

STEP 5

Clean the surface of the ceiling to ensure the double-stick

adhesive of the  xture bonds completely to the ceiling. Peel

off and discard the protective layer from the  xture’s

double-stick adhesive (Figure 4).

NOTE: CHROMASTEAM3 TO BE USED

WITH THE iSTEAM

3 ONLY.

WARNING The information in this guide is designed to provide a general overview of how MrSteam® products are installed. All images and diagrams are for illustrative purposes only

and may have been altered for presentation purposes. NEVER use this document for the Installation, Operation or Maintenance of any MrSteam® product. For installation, operation and

maintenance information and instructions, only use the applicable MrSteam® Installation, Operation & Maintenance Manual(s). The specific Installation, Operation & Maintenance manual

that is supplied with each MrSteam® product contains important information required for the safe and reliable installation and operation of the product. Failure to install any MrSteam®

product according to the applicable manual may result in property damage, an inoperable system/control, or hazardous condition. If you do not have the applicable Installation, Operation

& Maintenance manual please contact MrSteam® for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of

any MrSteam® product please contact a customer or technical service representative using the contact information on the back cover of this guide or consult a properly licensed contractor,

architect and/or design professional.

STEP 4

Connect the ChromaSteam3  xture’s pigtail to the 30-

foot control cable in the junction box (Figure 3).

For Illustrative purposes only. Consult with qualified designer, architect or contractor for

steamroom construction details.

FIGURE 4

FIGURE 5

FIGURE 6

FIGURE 3

MRSTEAM

GUIDE