Owners Manual

CHROMASTEAM 72
STEP 1
Determine the placement of the light.
STEP 5
Connect the quick connect tabs to the control board in
the generator at the location marked CHROMA.
STEP 6
Remove the red jumper wire shown in Figure 1 and
discard. Connect the wire from the steam generator to
the connector where the jumper was.
STEP 7
Connect the supply wires. Use suitable wirenuts (not
included) to insulate and secure the supply connections.
STEP 8
Connect copper ground wire from wiring box to ground
wire from electrical service using a wire nut to secure the
connection.
STEP 9
Insert the wired housing into the ceiling junction
box  rst.
STEP 2
The light requires a 41⁄4”diameter hole for mounting.
STEP 3
Provide electrical service (120VAC) with  exible cable
only. Pass cable through ceiling opening and wire  xture
in accordance with NEC and local electrical code.
STEP 4
Route the 30 foot cable supplied with the Chroma
Steam from your steam bath generator through one
of the knockouts in the ChromaSteam light wiring box.
Provide a suitable strain relief bushing.
IMPORTANT: The quick connect tabs should be on the generator
side, the Molex connector should be routed to the light (Figure 2).
For Illustrative purposes only. Consult with
qualified designer, architect or contractor
for steamroom construction details.
NOTE: CHROMASTEAM72
IS NOT FOR USE WITH
THE iSTEAM
®
3 CONTROL.
WARNING The information in this guide is designed to provide a general overview of how MrSteam® products are installed. All images and diagrams are for illustrative purposes only
and may have been altered for presentation purposes. NEVER use this document for the Installation, Operation or Maintenance of any MrSteam® product. For installation, operation and
maintenance information and instructions, only use the applicable MrSteam® Installation, Operation & Maintenance Manual(s). The specific Installation, Operation & Maintenance manual
that is supplied with each MrSteam® product contains important information required for the safe and reliable installation and operation of the product. Failure to install any MrSteam®
product according to the applicable manual may result in property damage, an inoperable system/control, or hazardous condition. If you do not have the applicable Installation, Operation
& Maintenance manual please contact MrSteam® for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of
any MrSteam® product please contact a customer or technical service representative using the contact information on the back cover of this guide or consult a properly licensed contractor,
architect and/or design professional.
LIGHT FIXTURE
LED CLUSTER
FIGURE 1
FIGURE 2
NOTE: FOR MOOD
LIGHTING ONLY.
IMPORTANT: DO NOT INSTALL THE FIXTURE
ASSEMBLY (LIGHT) WHERE DIRECT CONTACT
WITH STEAM OR WATER EMISSION COULD
OCCUR. DO NOT INSTALL THE LIGHT IN
A LOCATION WHERE IT COULD BECOME
SUBMERGED.
38MRSTEAM
®
GUIDE