Owners Manual

AUDIOSTEAM3
If using the wired input, connect a 1/8” (3.5 mm) stereo
audio cord (not included) to the auxiliary output, and
route the cable through the strain relief channel. Connect
the free end of the audio cord to an audio source.
STEP 4
Connect 10-pin MATE-N-LOK adapter with attached
wires — to the speaker outputs.
To operate the AudioSteam via iSteam3, you must
connect the AudioSteam (Figure 2) to an internal
connector in the steam generator.
STEP 5
Remove the steam generator cover and remove
knockout on steam generator. Plug the control cable into
the AudioSteam as shown. Connect the control cable
directly to the steam generator’s circuit board (A in
Figure 2).
STEP 6
Plug the AudioSteam power cord into a 120V grounded
electrical outlet. After the AudioSteam has been
powered, supply power to the steam generator.
STEP 1
Locate AudioSteam to prevent water from getting inside
the device,AudioSteam should be mounted on two stable
vertical surfaces (e.g., studs) as shown in (Figure 1).
Using screws and washers,  rmly attach AudioSteam
using the upper mounting holes, one at a time, on each
side of the unit. Repeat the process for the lower
mounting holes (Figure 1).
STEP 2
Using a Phillips-head screwdriver, remove the
two cover screws from the front of the AudioSteam
and remove the cover from the unit. Connect the outputs
of AudioSteam.
STEP 3
For best reception, fully deploy the FM antenna in a
vertical orientation outside of the AudioSteam housing.
For Illustrative purposes only. Consult with
qualified designer, architect or contractor
for steamroom construction details.
WARNING The information in this guide is designed to provide a general overview of how MrSteam® products are installed. All images and diagrams are for illustrative purposes only
and may have been altered for presentation purposes. NEVER use this document for the Installation, Operation or Maintenance of any MrSteam® product. For installation, operation and
maintenance information and instructions, only use the applicable MrSteam® Installation, Operation & Maintenance Manual(s). The specific Installation, Operation & Maintenance manual
that is supplied with each MrSteam® product contains important information required for the safe and reliable installation and operation of the product. Failure to install any MrSteam®
product according to the applicable manual may result in property damage, an inoperable system/control, or hazardous condition. If you do not have the applicable Installation, Operation
& Maintenance manual please contact MrSteam® for a free copy, or download a copy from www.mrsteam.com. If you have any questions about the installation, operation or maintenance of
any MrSteam® product please contact a customer or technical service representative using the contact information on the back cover of this guide or consult a properly licensed contractor,
architect and/or design professional.
FIGURE 1
FIGURE 2
A
CIRCUIT
BOARD
CONTROL
CABLE
PLUG INTO
STEAM GENERATOR
CONTROL CABLE
CONNECTION
PORT
POWER CORD TO
120V GROUNDED
OUTLET
39 MRSTEAM
®
GUIDE