Installation Guide

mr
.
steam
®
AromaSteam Operation and Installation Instructions
_____________________________________________________________________________________________
INSTALLER SECTION
10
Priming the Pump
1. Insure MrSteam fragrance container is full.
2. Insert a short piece of soft injector tube onto the tip of the injector
(see Fig. 1).
3. Insert the open end of the injector tube onto the pressure valve
(see Fig. 1).
4. Open the priming valve by turning the knob counter clockwise
one full revolution.
5. Draw liquid from the injector slowly and evenly.
Continue until the injector is full of liquid.
6. If you have drawn up the injector completely and no liquid
is in the injector, remove the injector tube from the pressure valve.
7. Drain injector. Repeat steps until the injector is filled.
8. Save the fragrance injector as it may be needed when new fragrances are used.
9. Close the priming valve completely by turning the knob clockwise.
Failing to close the valve will result in fragrance
leaking from the priming port.
IMPORTANT NOTE: If an extended pressure tube is special ordered
then contact MrSteam Technical Service (see page 20) for instructions
for filling the pressure tube with fragrance.
Priming Valve Knob
Soft Injector Tubing
Injector
CAUTION
!
Figure 1