Installation Guide

ManualsBrandsMr. Steam ManualsBatheSeries 12kW Steam Bath Generator

CARE TIPS FOR ALL CONTROLS AND

STEAMHEADS

1. Use only mild soap and water on a soft cloth to clean

the control and steamhead.

2. DO NOT use abrasive cleansers.

3. If the decorative cover is damaged on the iTempo

r iTempo/Plus call MrSteam technical service for

replacement parts.

NOTE: Replacement of the decorative covers requires

removal and reinstallation of the control from the mounting

surfaces.

STEAM GENERATOR MAINTENANCE

MrSteam steambath generators require little maintenance.

Other than periodic draining, maintenance procedures are mini-

mal. Every 2 months, or more often in “hard” water areas, the

manual drain valve should be opened fully flushing out accumu-

lated materials, salts and other particles which are natural by-

products of boiling water.

Flush a minimum of two-three hours after the con-

trol has been turned off to insure that the water has cooled.

Draining immediately after a steam cycle may

expose PVC and other piping to high temperature water. Check

local codes. The unit will refill automatically when the control is

activated again. In areas of hard water, a MrSteam AutoFlush

system is recommended for generator longevity.

Failure to allow the water to cool will expose the

equipment and user to scalding water and cause property and

personal injury.

IMPORTANT NOTE: The model and serial number is printed on

the data plate on the front of the steam bath generator.

steam

Installation, Operation & Maintenance Manual

__________________________________________________________________________

H O M E O W N E R

SETTING THE STEAM BATH

TEMPERATURE AND DURATION

Set the steam bathing temperature accord-

ing to personal preference, however it is highly recom-

mended to begin steam bathing at a low temperature set-

ing to gauge comfort and safety levels. Set duration to a

maximum of 10 minutes to gauge comfort and safety lev-

els. This will allow the steam generator to heat up and

begin producing steam.

SAFETY AND OPERATING

INFORMATION

DO NOT install or use any iSteam

AirTempo

, iTempo/Plus

, iTempo

, HomeWizard

iGenie

controls without reading and understanding the

MrSteam steam generator Installation and Operation

Manual. Failure to read and understand these instructions

may result in an inoperative or hazardous installation.

The peel and stick warning label located in

the manual provided with the steam bath generator must

be read and permanently affixed in a conspicuous location

near the steam room. Failure to read and affix this warning

sticker in a conspicuous location may result in serious injury

or death.

If an iSteam, AirTempo, iTempo or iTempo/Plus control is

installed outside the steam room a Remote Temperature

Probe (PN MSTS or iMSTS) must be installed inside the

steam room per installation instructions supplied with the

Remote Temperature Probe. Failure to install according to

instructions will result in an inoperative control and

overheating of the steam room.

To prevent slip and fall hazards non-skip

strips must be installed on the steam room floor.

DO NOT alter or modify any MrSteam

product. Doing so may result in an inoperative or

hazardous installation and will void the UL listing and

warranty.

IMPORTANT NOTES:

Malfunction due to power spikes,

lightning, fire, freezing or flooding is not covered under

the warranty.

Discontinue use of the steam generator or control if the

steam generator is damaged or otherwise not functioning

properly. Doing so may result in an inoperative or

hazardous condition.

WARNING

CAUTION