Installation Guide

mr
.
steam
®
______________________________________________________________________________________________________________
WALLSEAT INSTALLATION INSTRUCTIONS
Box Contents:
• Seat Assembly
• (2) Hinge Pins
• (1 ea.) Left & Right Brackets
• (1) Allen Wrench
• (4) #12 x 3" Wood Screws
• Silicone Sealant
• Installation Instructions
& Mounting Template
Required Tools
(not included):
• 5/32” Drill Bit
• #2 Phillips Bit
• Electric Drill
• 3/8" Tile Drill Bit
Read the entire WallSeat Installation instructions. Observe all local and National
building and safety codes. We recommend consulting a professional if you are
unfamiliar with this type of installation.
These instructions contain , and safety alert
symbols and panels. These alert symbols and panels identify potential safety hazards
and provide important information for the installation and use of the WallSeat.
Indicates a potentially hazardous situation, which, if not avoided, may
result in death or serious injury.
Indicates a potentially hazardous situation, which, if not avoided, may
result in minor or moderate injury or product damage.
is used to address practices not related to physical injury.
I N S TA L L E R S E C T I O N
Unpack and inspect the product for any shipping damage. If you find damages, do
not install. Contact Customer Service. If you need assistance or have questions about
installation of your WallSeat contact Customer or Technical Service
Installation Instructions:
1 Install Header. Header to be of materials and construction as re-
quired for the seat to support a minimum of 250 lbs. Typically, a
2"x 6" wooden header spanning across a minimum of three
studs is a sufficient minimum requirement, however, wood quality
and fastening methods vary and may impact structural integrity
and the ability of the seat to support 250 lbs. See figure 1.
THE MAXIMUM WEIGHT CAPACITY OF THE WALL-
SEAT IS 250 LBS. (113 kg) WHEN INSTALLED IN ACCORDANCE
WITH THESE INSTRUCTIONS. Exceeding the maximum weight
may cause mounting failure, resulting in serious injury. Persons
weighing more than 250 lbs. should not use the seat.
Failure to construct and test the header adequately
may result in WallSeat mounting failure and result in serious injury.
2. Mount the WallSeat on a suitable surface like tile, granite or marble.
Consult an architect, engineer or the material manufacturer to determine
if the material is suitable for the installation for a wall mounted seat.
NEVER mount the WallSeat to sheet-rock, drywall, plaster, fiberglass,
acrylic or other similar wall surfaces without the appropriate and required header.
Failure to heed this warning may cause serious injury.
NEVER mount the WallSeat to glass, glass tile or any other
materials prone to damage. Failure to heed this warning may cause serious injury.
Due to variances in local construction methods and materials used,
details given below are suggestions only. Consult the appropriate
local contractor for specific advice.
3. ALWAYS mount the WallSeat to a vertical wall of conventional, framed construction.
NEVER use the WallSeat for any other purpose. NEVER modify the WallSeat.
NEVER use metal studs.
mr
.
steam
®
Sussman-Automatic Corporation
®
Sales & Support:
1.800.76.STEAM (East Coast)
1.800.72.STEAM (West Coast)
[e-mail]
w ww.mrsteam.com
Products, information and specifications
are subject to change without notice.
Please call for more information.
WARRANTY To view
or download the WallSeat
Warranty and register go to:
blog.mrsteam.com/wr
33
1
/2
”
Fig. 1
Mounting Header