Installation Guide

mr
.
steam
®
Installation, Operation & Maintenance Manuals
_________________________________________________________________________
H O M E O W N E R
SETTING THE STEAM BATH TEMPERATURE AND DURATION
Set the steam bathing temperature according to personal preference, however it is highly
recommended to begin steam bathing at a low temperature setting to gauge comfort and safety levels.
Set duration to a maximum of 10 minutes to gauge comfort and safety levels. This will allow the steam
generator to heat up and begin producing steam while providing a short steam bath session.
23
The manual supplied with the generator includes a
peel and stick warning label. Its proper use is an essential part of
providing a safe environment for steam room users. The peel and
stick warning label must be applied to the wall of the shower or
steam enclosure, at a point that is visible to all users. Failure to install
this sticker may result in serious injury or death. The location where
this owner's manual is kept shall be written in the space provided on
the label using permanent ink. For a replacement warning label
contact MrSteam customer service at1-800-76-STEAM or
[e-mail].
Not Actual
Size
Applies to 14-17
14. The wet surfaces of steam enclosures may be slip-
pery. Use care when entering or leaving.
15. The steamhead is hot. Do not touch the steamhead
and avoid the steam near the steamhead.
16. The information in this manual should be used in
conjunction with consultations with an architect,
designer and contractor in determining factors nec-
essary in providing a suitable and safe steam room.
17. MrSteam steam generators are intended to be
operated with MrSteam controls and accessories
only, and are to be installed strictly in accordance
with the specific instructions contained in this manu-
al and as supplied in the manuals provided with the
controls or accessories.
Applies to 18-22
18. This document contains important safety, operation
and maintenance information. Do not discard this
document.
19. Read the Installation and Operation Manual of all
controls and accessories available at
www.mrsteam.com.
20. Record the model and serial number of the steam
generator in the space provided in the table of
contents of this manual.
21. If acrylic, fiberglass or other non-heat resistant
materials are used as part of the steam room enclo-
sure consult with the material manufacture and see
page 12, "Steamhead Installation" for additional
details.
22.
Carefully inspect the steam generator and packaging
for shipping damage. In the event of shipping dam-
age, please contact the carrier for claim information.
MrSteam customer service department can assist you
with any missing or damaged parts.
HYPERTHERMIA occurs when the internal temperature of the
body reaches a level several degrees above the normal body
temperature of 98.6° F. The symptoms of hyperthermia include
an increase in the internal temperature of the body, dizziness,
lethargy, drowsiness, and fainting. The effects of hyperthermia
include:
a) Failure to perceive heat;
b) Failure to recognize the need to exit the steambath;
c) Unawareness of impending risk;
d) Fetal damage in pregnant women;
e) Physical inability to exit the steambath
f) Unconsciousness.
The use of alcohol, drugs, or medication can greatly increase
the risk of hyperthermia.
IMPORTANT SAFETY INFORMATION (cont.)