Control Unit Installation Sheet

steam

INSTALLER INFORMATION

__________________________________________________________________

Installation with Optional Rough-In Box (cont.)

IMPORTANT NOTE: Be careful not to strain, staple, pinch or

otherwise damage the cables. Route cables as required to permit

replacement. Do not route cables inside conduit together with power

lines or close to hot water or steam piping.

STEP 6

Use the rough-in box as a guide to cut out the

⁄16” x 5

⁄4”) opening in the wall.

Finish the iSteam

3 installation using the instructions on page 7.

Installation without Rough-In Box

STEP 1

Make a 3

⁄16” x 5

⁄4” cut-out in the desired location using the

template provided on page 2 of this manual.

STEP 2

Route the control cable from the wall cutout to the steam

generator. Connect one end of the cable to the steam generator

connector. The two ends of the control cable are the same.

IMPORTANT NOTE: Be careful not to strain, staple, pinch or

otherwise damage the control cable. Route cable as required to

permit replacement. Do not route cable inside conduit together

with power lines or close to hot water or steam piping.

Finish the iSteam3 installation using the instructions on page 7.

Rough-In box used as

a guide to cut out the

opening.

⁄16”

⁄4”