Operating Guide

mr
.
steam
®
towelwarmers Installation, Operation & Maintenance Instructions
_________________________________________________________________
INSTALLER:
___________________________________________________
READ THIS ENTIRE INSTRUCTION MANUAL THOROUGHLY BEFORE
BEGINNING INSTALLATION. LEAVE THESE INSTRUCTIONS WITH
HOMEOWNER.
BE CERTAIN ELECTRICITY IS SHUT OFF AT
MAIN PANEL BEFORE ATTEMPTING TO WIRE OR SERVICE THE
TOWEL WARMER. Follow instructions to make certain the Towel
Warmer is properly mounted and secured to the wall.
FAILURE TO FOLLOW THESE STEPS COULD RESULT IN HAZARDOUS
CONDITIONS INCLUDING ELECTROCUTION.
1. Install in accordance with National and local codes.
2. Do not locate in shower stall, tub or near water spray.
3. Do not locate within
the shower or tub zone.
See illustration.
4. All models are to be
protected by dedicated
and suitably rated GFCI
circuit breaker or equal.
TO ENSURE CORRECT OPERATION OF YOUR TOWEL WARMER,
PLEASE FOLLOW ALL INSTRUCTIONS CAREFULLY, OBSERVING THE
"CAUTION" and “WARNING” NOTATIONS FOR EACH STEP.
Inspect Towel Warmer
Unpack the Towel Warmer carefully to avoid any damage or loss of
any part. When opening the box be sure that the parts are not
accidentally discarded. Towel Warmers are shipped in specially
designed shipping cartons. The entire surface of the Towel Warmer
is hand-wrapped to protect the finish. It is your responsibility to
immediately inspect for any damage.
3
TOWEL WARMER SPECIFICATIONS
_____________________________________________________________
Model No. Dimensions (inches) Amps Volts/Phase Weight (lbs.)
W x H x D
_____________________________________________________________
W328 20 x 31
3
⁄8 x 4
3
⁄4 0.82 120/1 10
F328 19
7
⁄8 x 34
3
⁄8 x 11
3
⁄4 0.82 120/1 10
W336 20 x 38
7
⁄8 x 4
3
⁄4 1.11 120/1 14
W348 20 x 49
1
⁄4 x 4
3
⁄4 1.40 120/1 18
HOMEOWNER:
_______________________________________________
THANK YOU for selecting Mr.Steam Towel Warmer, the perfect
addition to bathrooms, family spas, and exercise rooms within
your home. Our products have been a standard for quality and
comfort, and we are sure that you will experience continued
enjoyment from the Towel Warmer you have purchased by
following these instructions.
TOWEL WARMERS ARE HOT! The Towel
Warmer is an electrical heating appliance, intended only for
indoor residential applications and, as such, should be installed
and used with certain precautions for your safety.
1. INSTALLATION PROCEDURES FOR WALL-MOUNTED UNITS MUST
BE ACCOMPLISHED BY QUALIFIED PERSONNEL IN STRICT
ACCORD WITH APPLICABLE NATIONAL AND LOCAL BUILDING
AND ELECTRICAL CODES.
2. DO NOT place TOWEL WARMER units inside a shower, sauna or
steam room enclosure or any other wet location or with
elevated temperature because the towel warmer may be an
electrocution hazard.
3. CAUTION is advised when a Towel Warmer is accessible to
children because the towel warmer is hot.
4. A dedicated wall switch or timer should be used to control the
TOWEL WARMER unit. Contact Mr.Steam for an in-wall 24-hour-
7 day timer (PN W-103588DIG) Note: All switches and control
devices must be installed on the load (black) side of the Towel
Warmer circuit in compliance with the National Electrical Code
(NEC) and local code. (see page 6 for installation instructions)
IMPORTANT: The finish of your Towel Warmer can be
protected and maintained by an occasional wiping with a soft,
non-abrasive, damp cloth and lightly polished, thereafter, with a
soft dry cloth when the Towel Warmer is cold. Under no circum-
stances should abrasive cleaning powders, metal polish or chlo-
rine-based cleaners be used on any part of this product.
IMPORTANT: This appliance is for warming towels only.
DO NOT use this appliance to dry wet towels.
IMPORTANT: This appliance is intended for towels washed in
water. Fabrics that contain soap or detergent residue may show
what appears to be scorch marks. However this may be the dis-
coloration of the residue. Mr.Steam is not responsible for discolor-
ing or damage of any fabrics. Refer to the Mr.Steam towel warmer
warranty for additional terms and conditions.
For illustrative purposes only
!
WA RN IN G
!
WA RN IN G
!
WA RN IN G
Shower/Tub
Zone
Do not locate the
towel warmer within
the shower/tub zone
This picture shows the recommended
method of draping a towel on a towel
warmer. Ensure as much as possible of
the towel's surface is touching the towel
warmer for optimum towel warming.
Note: Dimensions are approximate
Note: Hard wired and cord connected models have the same dimensions, amps
and weight. Cord connected models include an integral 6 foot power cord.