Operating Guide

MOUNTING DIMENSIONS
Note: “C” dimension is not applicable for cord connected models
IMPORTANT NOTE: Towel Warmers may have small
dimensional variations and must be measured prior
to installation. Do not use dimensions to determine
location of mounting holes.
mr
.
steam
®
towelwarmers Installation, Operation & Maintenance Instructions
_________________________________________________________________
4
WALL PREPARATION
• DO NOT mount the Towel Warmer without providing
structurally secure upper and lower headers as shown.
• DO NOT mount the Towel Warmer directly to sheet
rock or any other non-structural surface.
• Use longer fasteners as required if the finished wall surface
prevents adequate mounting with the screws provided.
• Provide a clearance hole in the lower header as required
to route field wiring to the Towel Warmer wiring box.
(not applicable for cord connected models)
IMPORTANT NOTE: See electrical rough-in instruc-
tions on page 6.
IMPORTANT NOTE: Towel Warmers may have small
dimensional variations and must be measured prior to
installation. Do not use dimensions to determine
location of mounting holes.
!
CA UT IO N
MOUNTING DIMENSIONS (inches)
Hard Wired & Cord Connected
MODEL ABC
W328 18
7
⁄
16
17
15
⁄
16
7
1
⁄
4
W336 18
7
⁄
16
25
9
⁄
16
7
1
⁄
4
W348 18
7
⁄
16
35
3
⁄
4
7
1
⁄
4
This
End
Up
Wiring Box
U
p
p
e
r
H
e
a
d
e
r
(
Z
)
Lo
w
e
r
H
e
a
d
e
r
(
Z
)
Finished
wall surface
Towel Warmer
MOUNTING DIMENSIONS (inches)
Hard Wired & Cord Connected
MODEL X(min) Y Z (min)
(Header horizontal length) (Header vertical length) (Header size)
W328 19 17
15
⁄ 16 2 x 6
W336 19 25
9
⁄ 16 2 x 6
W348 19 35
3
⁄ 4 2 x 6
For Technical Service Assistance:
East Coast Tel: [phone]
West Coast Tel: [phone]