Operating Guide

mr
.
steam
®
towelwarmers
Installation, Operation & Maintenance Instructions
_________________________________________________________________
5
INSTALLATION:
W328, W336, W348
TO PREVENT SHOCK HAZARD, THE ELECTRICITY MUST BE
TURNED OFF AT THE MAIN PANEL BEFORE ANY WIRING IS DONE.
IMPORTANT NOTE:
See electrical rough-in instructions on page 6.
Install Towel Warmers in upright position only. Locate with wiring
box on bottom as shown. Failure to install properly may result
in a hazardous condition. See page 4.
!
WA RN IN G
!
WA RN IN G
A
llen
Wrench
Wiring Box
Mounting
Bracket
Mounting
Screw
Towel
Warmer
Mounting
Bolt
Sleeve
Extension
7. Slide the towel warmer onto
the mounting brackets. Mark
the location for the wiring box
escutcheon.
8. Remove the towel warmer and
secure the escutcheon to the
wall per the instructions on
page 6.
9. Slide the towel warmer onto the mounting
brackets. Secure the towel warmer in place
using the mounting bracket set screws.
1. Remove Towel Warmer and
parts from the packing
materials.
2. Using the allen key provided,
loosen the wiring box set
screw. DO NOT remove the
wiring box.
3. Gently rotate the wiring box as
shown. Tighten the set screw
firmly to prevent the wiring
box from rotating.
4. Locate the mounting brackets
on the wall by measuring the
mounting holes on the towel
warmer.
5. Using the screws provided
secure the brackets to the wall.
6. Insert the sleeves into the
extensions. Using the
mounting bolts secure the
extensions and sleeves to
the 4 threaded holes on
the towel warmer.
Wiring Box
Escutcheon
Escutcheon
Set Screw
Wiring Box
Mounting Bracket
Extension
Mounting
Bracket
Set Screw
(4) Mounting bolts
(4) Sleeves
(4) Extensions
Wiring box escutcheon
(2) Allen wrenches
Instructions
Warranty
BOX CONTENTS:
Towel Warmer
(4) Mounting Screws
(3) Wiring Box Mounting Screws
(2) Wiring Box Set Screws
(4) Mounting Brackets
(4) Mounting bracket Set Screw
(Note:
Cord connected models use
4
knurled thumb screws
)