Operating Guide

TO PREVENT ELECTRIC SHOCK HAZARD, NO BARE WIRE
OR WIRE STRANDS SHALL BE EXPOSED AFTER MAKING CONNECTIONS.
Towel Warmer surface may continue to be hot for a period
of time after it has been turned off.
INSTALLATION: MODEL F328
BOX CONTENTS:
• Towel Warmer with 6' Grounding Type
Power Cord
• (2) Legs
• (2) Leg Screws
• (1) Large Allen Key
• (2) Spacers
• Instruction & Operation Manual
• Warranty
1. With the unit unplugged, assemble the tubular legs
to the bottom of the Towel Warmer as shown.
2. DO NOT OVERTIGHTEN!
Locate F328 on a flat hard surface.
Failure to do so may result in an unstable installation
resulting in a hazardous condition.
Towel Warmer
Spacer
Leg
Leg Screw
Allen Wrench
IMPORTANT: DO NOT
OVERTIGHTEN!
mr
.
steam
®
towelwarmers Installation, Operation & Maintenance Instructions
_________________________________________________________________
7
AVAILABLE DIGITAL PROGRAMMABLE TIMER
1. Read the operating instructions provided with the timer.
2. Disconnect power supply prior to installation to prevent electrical shock.
3. Damage to the contacts caused by short circuiting will void the warranty.
4. Wire in accordance with National Electrical and Local Code requirements.
Be sure all connections are secure. Double check all twist-on wire connectors.
5. Mount timer into a single gang wall box using supplied screws.
6. If timer does not operate, check that the timer's black wire is connected to
hot line and not the load. If necessary, reverse connections to red and black wires
7. When the indicator light on the towel warmer is illuminated, the towel
warmer is energized.
AVAILABLE DECORATIVE
FACE PLATES FOR TIMER:
Brushed Stainless Steel 103872D-SB
Polished Stainless Steel 103872D-SP
GENERAL:
The Towel Warmer requires 120 VAC, 50/60
Hz power. Specific amperage needed is listed
in the Towel Warmer Specifications
Chart on page 3 of this manual.
A.
Electrical connections should be made as
prescribed by the National Electrical Code
and local code. The unit should be field
wired using 14 AWG min 90°C-rated insu-
lated copper wire. All models are to be pro-
tected by a separate 15 amp circuit break-
er, GFCI or equal.
B. Make connections between Towel Warmer and
house wiring using approved connections to
comply with the National Electrical Code and
local codes. LINE (black), NEUTRAL
(white), and GROUND.
Electric Towel Warmer
Element
Heating Element Wiring Box
Field Wiring
L
N
GRND
L
N
GRND
Field Installed Wall Switch or
Mr. Steam Digital Programmable Timer
PN: 103588DIG
Indicator Light
X
X
X
!
CA UT IO N
!
CA UT IO N
!
WA RN IN G
!
WA RN IN G