Operating Guide

ManualsBrandsMr Steam ManualsTowel WarmersW500PC

steam

towelwarmers Hydronic Models

_________________________________________________________________

Installation and Operating Instructions

When all connections are complete, vent the unit using the

bleed valve as shown.

DO NOT TURN THE VALVE BODY, TURN THE

UNION ONLY. TURNING THE VALVE MAY RESULT IN LEAKS

Check all connections for leaks.

DO NOT open the bleed screw when the

unit is pressurized as hot water may present a scalding hazard.

(see Step 6 in installation)

___________________________________________________

Bleed screw location for Bleed screw location

models H542, H552, H562 for model H572

Make sure the bleed screw is securely

tightened and not leaking.

STEP 4: OPERATION & MAINTENANCE

CLEANING:

The finish of your Mr.Steam Towel Warmer can be

protected and maintained by an occasional wiping with a damp cloth

and lightly polished thereafter with a soft dry cloth. Under no

circumstances should abrasive cleaning powders or metal polish be

used on any part of a chrome or gold plated Towel Warmer.

A.Mounting:

The Mr.Steam Towel Warmer has been designed with integral mount-

ing brackets. These will facilitate a permanent and secure mounting

of the Towel Warmer to the wall using the screws provided.

Locate the brass inserts

according to the

following chart:

(All inlet/outlet pipes

are 18

/2" apart.)

Slide a bracket escutcheon (with the 'O' ring facing the towel

warmer) on each of the mounting brackets.

Slide the towel warmer on the brass inserts and tighten the set

screws on both brackets. Slide the escutcheons against the wall to

hide the joint.

The recommended location for optional lower brackets is on the

bottom rung of the Towel Warmer, a sufficient header should be

provided for these brackets.

B. Valve Installation:

Place a washer between the threaded portion of the valve and the

Towel Warmer union. carefully tighten the union to secure the valve

to the Towel Warmer.

Slide the escutcheon onto the valve over the valve union.

After the plumbing has been prepared as described place a washer

between the valve union and coupling. Carefully tighten the union to

connect the valve to the plumbing.

Slide the escutcheon over the valve union to cover the inlet and out-

let plumbing.

IMPORTANT:

There are two valves which come with Mr.Steam Hydronic

Towel Warmers. One valve should always be left open, the other valve can

be opened or closed. These valves seal only in the fully open (turn valve

handle counter clockwise) or full closed (turn valve handle clockwise) posi-

tion. Using the valve to throttle the water flow will result in a leak at the

valve stem.

CAUTION

WARNING

CAUTION

Finished

face of wall

Escutcheon

Upright tube

Union

Turn this union only

to assemble the valve

to the upright tube

Hydronic

Towel Warmer

Towel warmer

union

Washer

Valve

Supplied with

Towel Warmer

Field Supplied

Eccentric

coupling

(optional)

Straight

coupling

(or similar)

Field

Plumbing

Escutcheon

Washer

Valve Union

1/2" Pipe

(field supplied)

Washer

Valve

Optional eccentric

coupling (supplied)

Do not spin this valve onto the

upright tube as this may cause

upright joints to loosen and leak

WARNING

HYDRONIC HOOK-UP VALVE INSTALLATION

WARNING

STEP 3: INSTALLATION

Vertical Distance from

Model Inlet/Outlet pipe centerline

H542

⁄16

H552

⁄16

H562

⁄16

H572

⁄16