Operating Guide

steam

towelwarmers Electric Models

_________________________________________________________________

Installation and Operating Instructions

ELECTRICAL SPECIFICATIONS

Field Wired Models:

W500, W510, W542, W552, W554, W562, W572, W634,

842

Plug-in Models: W556, W856

ELECTRICAL CONNECTIONS

TO PREVENT SHOCK HAZARD, BE CERTAIN THAT ELECTRICITY IS TURNED OFF AT THE MAIN PANEL

BEFORE ANY WIRING IS DONE.

All wiring must conform to National Electrical and Local Codes.

GENERAL:

The Towel Warmer requires 120VAC, 60 Hz power supply.

Specific amperage needed is listed in the Towel Warmer Specifications Chart on page 2 of

PUR

103852.

A. Electrical connections should be made as prescribed by the National Electric and Local Codes. The unit should be

field wired using 14 AWG min 90°C-rated copper wire. All models are to be protected by a separate 15 amp circuit breaker or equal.

B. Make connections between Towel Warmer and house wiring using approved connections to comply with National Electrical Local Codes.

LINE (black), NEUTRAL (white), and GROUND.

C. Install the Towel Warmer according to the specific instructions for each model

TO PREVENT SHOCK HAZARD, NO BARE WIRE OR WIRE STRANDS SHOULD

BE VISIBLE AFTER MAKING CONNECTIONS.

Electric Towel Warmer

Thermal Fuse

Thermostat

Heating Element Wiring Box

Field Wiring

GRND

Field Installed Wall Switch or

Mr. Steam Digital Programmable Timer

PN: 103588DIG

Indicator Light

WARNING