Operating Guide

steam

towelwarmers Electric Models

_________________________________________________________________

Installation and Operating Instructions

MODELS W500 & W510

TO PREVENT SHOCK HAZARD, BE CERTAIN

THAT ELECTRICITY IS TURNED OFF AT THE MAIN PANEL BEFORE

ANY WIRING IS DONE.

BOX CONTENTS:

• Towel Warmer

• (6) Screws

• (1) Upper Threaded Flange

• (1) Lower Wiring Flange

• (1) Small Allen Key

• (1) Large Allen Key

• Instruction & Operation Manual

• Warranty

1. Remove the Towel Warmer and parts from the packing materials.

2. Rotate the upper bracket as shown.

IMPORTANT:

DO NOT LOOSEN SCREWS TO SWIVEL

BRACKETS. LOOSENING SCREWS WILL CAUSE INTERNAL

LIQUID TO ESCAPE AND CAUSE PRODUCT DAMAGE.

3. Spin on upper threaded flange as shown.

4. Using the smaller allen key provided, loosen the wiring box

set screw. DO NOT remove the wiring box.

5. Rotate the wiring box as shown. Tighten the set screw firmly to prevent

the wiring box from rotating.

6. Place the Towel Warmer in the desired location and mark the

location of the upper threaded flange and wiring box. Use a level to

insure proper alignment.

NOTE:

the Towel Warmer swing range.

7. Mount the lower wiring box per instructions on page 10.

If a single gang electric box has been roughed-in,

then see page 3 for installation instructions.

Install Towel Warmers in upright position only. Locate with

indicator light on bottom as shown. Failure to install properly may result in

overheating and a hazardous condition.

Level

Upper Support Bracket

Upper Threaded Flange

Wiring

Box

WARNING

This

End