Operating Guide

steam

towelwarmers Electric Models

_________________________________________________________________

Installation and Operating Instructions

NOTE:

The Towel Warmer wires are color coded:

BLACK for LINE, WHITE for NEUTRAL, GREEN/YELLOW for EQUIPMENT GROUND.

If a single gang electric box has been roughed-in, see page 3 for instructions

Install Towel Warmers in upright position only. Locate with switch on bottom as shown.

Failure to install properly may result in overheating and a hazardous condition.

Wiring Box Set Screw(s)

Wiring Box

Wiring Flange

Wiring Box

Wiring Flange

BX Connector Lock Nut

BX Cable*

(or greenfield)

WARNING

2. Secure wiring flange to the

wall with screws provided.

(Use longer screws as required

by construction conditions.)

4. Slide the wiring box onto the wiring flange and tighten

the set screw firmly. Secure the upper threaded flanges

and lower bracket with screws provided.

ELECTRICAL CONNECTIONS

Models

W500, W510, W542, W552, W554, W562, W572, W634,

842

TO PREVENT SHOCK HAZARD, BE CERTAIN THAT ELECTRICITY IS TURNED OFF AT THE MAIN PANEL BEFORE ANY WIRING IS DONE.

The towel warmer is an electronically operated device. It must be installed by a licensed electrician

in accordance with local code and the National Electric Code (NEC).

Install a wall switch or timer to turn the towel warmer on and off.

NOTE: When the towel warmer is energized, the indicator light on the towel warmer will illuminate.

1. Assemble the BX cable connector to the wiring flange as shown.

NOTE:

NM (non-metallic) cable, if permitted by National

and Local Codes may be used instead of BX cable

3. Connect wiring per instructions page 3.

WARNING

CAUTION