Operating Guide

mr
.
steam
®
towelwarmers Electric Models
_________________________________________________________________
Installation and Operating Instructions
3
WALL PREPARATION
• DO NOT mount the Towel Warmer without
providing structurally secure headers as shown.
• DO NOT mount the Towel Warmer directly to sheet
rock or any other non-structural surface.
• Use longer fasteners as required if the finished wall surface
prevents adequate mounting with the screws provided.
• Provide a clearance hole in the lower header as required
to route field wiring to the Towel Warmer wiring box.
If a single gang electric box has been roughed-in, install cover plate
PN103877. See part numbers below for decorative finish information.
DO NOT install the Towel Warmer without these instructions.
Cover Plate Part Numbers & Decorative Finishes:
Polished Chrome 103877PC
Polished Brass 103877PB
Polished Nickel 103877PN
Pewter 103877P
Satin Nickel 103877SN
Polished Gold 103877 PG
Satin Gold 103877SG
Antique Brass 103877AB
Oil Rubbed Bronze 103877ORB
IMPORTANT NOTE: Towel Warmers may have small dimensional
variations and must be measured prior to installation.
For Technical Service Assistance:
East Coast Tel: [phone]
West Coast Tel: [phone]
Lower Header (Z)
Upper Header (Z)
Lower Header (Z)
Upper Header (Z)
Wiring Box
X
Y
Wiring
Box
Finished
wall surface
Finished
wall surface
Y
X
!
CAUTION
!
WARNING
MOUNTING DIMENSIONS (inches)
MODEL X(min) Y Z (min)
(Header horizontal length) (Header vertical length) (Header size)
W 500 5 22
5
⁄
8
2 x 6
W 510 5 16
1
⁄8 2 x 6
W 542 23
1
⁄4 24
3
⁄4 2 x 6
W 552 23
1
⁄4 23
3
⁄4 2 x 6
W 554 23
1
⁄4 20
5
⁄16 2 x 6
W 562 23
1
⁄4 23
3
⁄16 2 x 6
W 572 23
1
⁄4 24
3
⁄4 2 x 6
W 634 19 27
1
⁄8 2 x 6
W 842 23 23
1
⁄4 2 x 6