Installation Guide

Page 21 mrcool.com
Outdoor Unit Installation
Outdoor Unit Dimensions (inches)
Width (W) x Height (H) x Depth (D)
Mounting Dimensions (inches)
Width (A) Depth (B)
30.31 x 21.85 x 11.81 (inches)
769.87 x 555 x 300 mm
19.2 in.
487.68 mm
11.73 in.
297.94 mm
31.50 x 21.81 x 13.11 (inches)
800.10 x 553.97 x 332.99 mm
-- in.
-- mm
-- in.
-- mm
31.50 x 21.81 x 13.11 (inches)
800.10 x 553.97 x 332.99 mm
-- in.
-- mm
-- in.
-- mm
33.27 x 27.64 x 14.29 (inches)
845.06 x 702.06 x 362.97 mm
37.24 x 31.89 x 16.14 (inches)
945.89 x 810.00 x 409.95 mm
21.26 in.
540 mm
-- in.
-- mm
13.8 in.
350.52 mm
-- in.
-- mm
A-09-HP-C-115B
A-09-HP-C-230B
A-18-HP-C-230B
A-12-HP-C-115B
A-12-HP-C-230B
A-24-HP-C-230B
A-36-HP-C-230B
WHEN DRILLING INTO CONCRETE,
EYE PROTECTION IS RECOMMENDED
AT ALL TIMES.
W
H
D
Air Inlet
A
B
Air Outlet
Air Inlet
Fig. 5.5
If you will install the unit on the ground or on a
concrete mounting platform, do the following:
1. Mark the positions for four expansion bolts
based on dimensions in the Unit Mounting
Dimensions chart.
2. Pre-drill holes for expansion bolts.
3. Clean concrete dust away from holes.
4. Place a nut on the end of each expansion bolt.
5. Hammer expansion bolts into the pre-drilled
holes.
Step 3: Anchor outdoor unit
The outdoor unit can be anchored to the ground
or to a wall-mounted bracket.
UNIT MOUNTING DIMENSIONS
The following is a list of different outdoor unit
sizes and the distance between their
mounting feet. Prepare the installation base
of the unit according to the dimensions below.
6. Remove the nuts from expansion bolts, and
place outdoor unit on bolts.
7. Put washer on each expansion bolt, then
replace the nuts.
8. Using a wrench, tighten each nut until snug.