Use and Care Manual

12
For the models with the Plasma filter, do not touch the
plasma for 10 minutes after you open the panel. Clean the
Plasma according to the describtion in the figure to the
left.
5. Refit the small air freshening filter onto the large air
filter.
6. Re-insert into unit in the reverse order described in
point 2 above.
7. Close the front panel. Make sure the buckles are fully fit
and the panel is completely closed.
Preparation for extended non-operation
If you plan to idle the unit for a long time, perform the
following:
1. Clean the indoor unit and filters.
2. Operate the fan for about half a day to dry the inside of
the unit.
3. Stop the air conditioner and disconnect power.
4. Remove the batteries from the remote control. The
outdoor unit requires periodic maintenance and cleaning.
Do not attempt to do this yourself. Contact your dealer or
service provider.
Pre-season inspection
•Damaged or disconnected wires.
•Clean the indoor unit and filters.
•Check water or oil leaks.
•Check if the air outlet or inlet is blocked after the air
conditioner has not been used for a long time.
CAUTION
•Do not touch the metal parts of the unit when removing
the filter. Injuries can occur when handling sharp metal
edges.
•Do not use water to clean inside the air conditioner.
Exposure to water can destroy the insulation, leading to
possible electric shock.
•When cleaning the unit, first make sure that the power
and circuit breaker are turned off.
•Do not wash air filter with hot water at more than
104°F / 40°C. Shake off moisture completely and dry it in
the shade. Do not expose it directly to the sun, it may
shrink.
Plasma
(optional)
Open the panel and take down the
Plasma lter by holding the upper
of the Plasma and lifting it upwards
according to the arrows.
Releasing the buckles as indicated
with arrows and open the cover of the
Plasma, clean or replace the lter
with vacuum.
Dust collector lter(optional)
2
Panel buckles
CARE AND MAINTENANCE