Remote Manual

Page 18mrcool.com
How To Use Advanced Functions
ECO function
Under COOL mode, press this button and the remote controller will automatically adjust the
temperature to 75°F (24°C), fan speed off of AUTO to save energy. However, this only occurs when
the set temperature is less than 75°F (24°C). If the set temperature is above 75°F (24°C), pressing the
ECO button will cause the fan speed to change to AUTO and the set temperature will remain
unchanged.
NOTE:
• Pressing the ECO/GEAR button, modifying the mode, or adjusting the set temperature to
less than 75°F (24°C), will stop ECO operation.
• Under ECO operation, the set temperature should be 75°F (24°C) or above, or it may result in
insufficient cooling. If the cooling feels insufficient, press the ECO button again to turn off
this feature.
Pressing the ECO button will enter the unit into energy efficiency mode.
NOTE: This function is only available under the COOL mode.
ECO operation:
FP function
LOCK function
Clean
5s
5s
Turbo
Using this function will cause the unit to operate with a high fan speed setting
(while the compressor is on) with temperature automatically set to the lowest
setting, 46°F (8°C), in order to achieve faster cooling.
2
+
Pressing the CLEAN and TURBO buttons at the same time for
more than 5 seconds will activate the LOCK function.
With this feature activated no buttons pressed will respond,
except when these two buttons are pressed again for two
seconds in order to disable the LOCK function.
Press the button 2 times within one second while in HEAT Mode and the temperature will be set to
60°F (16°C) or 68°F (20°C) (dependent on model) and the FP function will be activated.
Pressing the On/Off, Sleep, Mode, Fan or Temperature buttons while operating this function will
cancel it.
NOTE: The function listed below is for heat pump air conditioners only.