Remote Control Manual

How To Use The Buttons
Page 7 mrcool.com
4
MODE
FA N
TE MP
ON/OF F
TIME R
ON
TIME R
OF F
1
3
2
MODE
FA N
TE MP
ON/OF F
S ILE NC E
F P
S ILE NCE
F P
TIME R
ON
TIME R
OF F
1
2
LE D F OLLOW
ME
LE D F OLLOW
ME
TURBO SE LF
C LE AN
TURBO SE LF
C LE AN
S WING DIR E C T
S WING DIR E C T
S LE E P
S LE E P
Auto Operation
Ensure the indoor and outdoor unit is properly wired to an appropriate power
source and the power is on. The display should be lit on both the remote and
indoor unit (assuming the indoor unit has not been turned off by using the LED
button on the remote).
1. Press the MODE button to select AUTO.
2. Press the UP/DOWN button to set the desired temperature. The
temperature can be set within a range of 62°F (16°C) to 86° F (30°C), and
adjusted in 1° increments (°F or °C depending on mode).
Cooling/Heating/Fan Operation
Ensure the unit is properly wired to an appropriate power source
and the power is on.
1. Press the MODE button to select COOL, HEAT, or FAN mode.
2. Press the UP/DOWN button to set the desired temperature. The
temperature can be set within a range of 62° F (16°C) to 86° F (30°C) in 1°
increments (°F or °C depending on mode).
3. Press the FAN button to select the desired fan setting. The fan settings are:
Auto, Low, Med, or High.
NOTE
1.
In AUTO mode, the air conditioner can automaticallly select the
appropriate mode (COOL, FAN, or HEAT) by sensing the difference
between the actual ambient room temperature and the
temperature setting on the remote control.
2. In the AUTO mode, you cannot adjust the fan speed. It will be
automatically controlled.
3. To deactivate AUTO mode, the select desired mode manually on
the remote.
NOTE
In the FAN mode, the setting temperature is not displayed on the
remote control, and it will not control the room temperature. In this
case, only steps 1 and 3 may be performed.