Lacey Act Declaration Form

Page 17
Care and Maintenance
mrcool.com
Panel buckles
3. Then, extract the filter by gently drawing it
downward. Replace as necessary.
4. Unclip the small air freshening filter from the larger
air filter. Replace if necessary. Otherwise, clean it
with a vacuum and clip it back into place after
cleaning the larger air filter as outlined in step 5.
5. Clean the large air filter with warm, soapy water. Be
sure to use a mild detergent and rinse with fresh
water. Shake off the excess water and allow it to dry
in a cool area.
6. Re-clip the small air freshening filter into the large air
filter by reversing step 4.
7. Re-fit air filter back into the unit by reversing steps 2
and 3 by gently pushing the top of the filter up into
the unit and then lowering the bottom portion into
place.
8. Close the front panel of the unit. Make sure that it
buckles securely and the panel is completely closed.
Preparation for Extended Non-Operation:
If you plan to not run the unit for an extended period of
time (e.g. from the end of summer to the beginning of
the following summer), perform the following:
1. Clean the indoor unit and filters as outlined in the
previous steps.
2. Operate the unit in FAN-Only mode for at least 8
hours to dry out the inside of the unit.
3. Turn off the unit. Then, turn off the power to the
circuit at the breaker. The unit should be the only
appliance on this circuit.
4. Remove the batteries from the remote control.
5. The outdoor unit also requires periodic maintenance.
However, it is highly recommended you contact a
qualified service professional to perform this. Please
do not attempt to do this on your own.
Pre-Season Inspection:
After prolonged non-operation perform the following:
1. Use a dry cloth to wipe off any dust that has
accumulated on the rear air intake grille. This will
avoid any dust from being dispersed from the indoor
unit.
2. Check for any damaged or disconnected wires.
3. Clean or replace the filters and ensure they properly
installed.
4. Check for water and oil leaks.
5. Check for blockages in the airflow inlet and outlet.
6. Replace batteries in the remote control.
Removal
Install
5
3
4 & 6
7
8