The Signature Series is NOT designed for amateur installation. Installation SHOULD be performed by an authorized technician. Please read this manual carefully before installation and keep it for future reference. User’s Information Manual Signature Series Gas Heating/Electric Cooling Package Unit The Signature Series is NOT designed for amateur installation. Installation SHOULD be performed by an authorized technician.
USER’S INFORMATION MANUAL Package Unit Save these instructions for future reference Congratulations... ...your outdoor heating/cooling package unit is a valuable piece of equipment, designed and manufactured by the most modern methods. Proper care of your unit should result in many years of service and comfort. To keep your operating costs low and to eliminate unnecessary service calls, we have provided a few guidelines.
IMPORTANT SAFETY INFORMATION automatically lights the burners. See OPERATING YOUR UNIT on page 3 for information on lighting and shutting down the unit. WARNING 4. Should the gas supply fail to shut off or if overheating occurs, shut off the gas valve to the unit before shutting off the electrical supply. OR EXPLOSION HAZARD Failure to follow the safety warnings exactly could result in dangerous operation, serious injury, death, or property damage. 5.
OPERATING YOUR UNIT These units are equipped with an ignition device which automatically lights the burners. 7. Wait 5 minutes to clear out any gas, then smell for gas (including at the bottom of the unit near the ground). If you smell gas, stop and follow the directions in WHAT TO DO IF YOU SMELL GAS on page 1. If you don’t smell gas, continue to next step. smell around furnace area for gas. Be sure to smell near the unit base because some gas is heavier than air and will settle to the lowest point.
MAINTENANCE OF YOUR UNIT There are many types and styles of thermostats. However, almost all thermostats perform the same basic functions described in the following section. Thermostat Operation There are two switches located on the thermostat. One switch controls the heating and cooling functions. The other switch is for “FAN” operation, either continuous or automatic. On the thermostat is the temperature range for the heating temperature and the cooling temperature desired.
for assistance. Contact your dealer if you desire more information about this important safety feature. Should you observe unusual amounts of any of the following conditions, it is important that you call your authorized dealer Should any unusual conditions be observed during your inspections, call an authorized service dealer immediately. • • Return Air All return air duct connections must be tight and sealed to unit cabinet. Supply and return air registers must be open when the unit is in operation.
Model # _________________________________ Lubrication of the bearings in the circulating air blower motor and the combustion blower motor is not recommended. Serial # _________________________________ Installation Date___________________________ Installed by: and motors will become dust laden after long months of operation. The entire blower assembly should be inspected annually. If the motor and wheel are heavily coated with dust, they can be brushed and cleaned with a vacuum cleaner.
Signature Series Gas Heating/Electric Cooling Package Unit ELECTRICIAN and/or HVAC TECHNICIAN: LICENSE #: INSTALLATION DATE: INSTALLATION LOCATION: SERIAL NUMBER: The design and specifications of this product and/or manual are subject to change without prior notice. Consult with the sales agency or manufacturer for details.
