Use and Care Manual

Page 6 of 6 507302-01Cmrcool.com
Model # _________________________________
Serial # _________________________________
Installation Date___________________________
Installed by:
Dealer __________________________________
Address _________________________________
Telephone #______________________________
License # ________________________________
Lubrication of the bearings in the circulating air blower motor
and the combustion blower motor is not recommended.
and motors will become dust laden after long months of
operation. The entire blower assembly should be inspected
annually. If the motor and wheel are heavily coated with
dust, they can be brushed and cleaned with a vacuum
cleaner.
Compare these observations to Figure 3 to determine if
service dealer for service.
Your service representative will perform this adjustment
correctly.
This unit is equipped with a manual reset high temperature
sensor or rollout switch. In the unlikely event of a sustained
gas by closing the gas valve. The switch is located inside the
gas burner area. Flame rollout can be caused by blockage
of the power vent system, a blocked heat exchanger, or
improper gas pressure or adjustment. If this event occurs,
the unit will not operate properly. The gas supply to the
unit should be shut off and
The system should be inspected
Figure 3