Before starting up; read this manual carefully and keep it for future reference, INVERTER SPLIT-TYPE ROOM AIR CONDITIONER HEAT PUMP INSTALLATION MANUAL (9K & 12K MODELS) ro. AT Y cooler COMFORT MADE SIMPLE Oasis For more details visit www.
Please read this installation manual carefully before operating the unit to ensure: correct installation. If the power cord is'damaged, replacement work shall be performed by authorized personnel only. Installation must be performed in accordance with the requirement NEC arid CEC by-authorized personnel only: Contact unauthorized service technician for repair, maintenance and installations of this unit; This appliance is not intended for use by petsons{ingluding children) with reduced physical, sensory.
Ensure the mounting Wallis strong and solid Reasoner ot more to cling gig, Troubleshooting = 120mm of & rime toil pay Right sear side hr 189, enough to protect it farm vibration. i Grin oi smote to val @® Installation Plate Mourning pi Fit installation plate horizontally on freemen te strict parts of the wall with spaces eh B55 refrigerant thunderhead installation plate. 2440 the wall is made of brick, concrete or similar material, dell five or eight DAS ot more ta selling.
Electrical work Electric safety regulations fof the initial installation 1. if there are serious safety problems regarding the power supply, the technicians) should refuse to ms tali the air conditioner until the problems solved, 2, Power voltage should be in the fangs of of rated voltage, 3. Equipment must be properly grounded. Any disconnect and altogether components in the power supply circuit: should be rated for ng less than 1.5 times the equipment rating. 4.
REE EI ET NOTE: The drain joint may differ depending on the outdoor uit. For-the drain joint with the first fit the seal onto the drain Sal Dumpiness Base pan hole joint, then insert the drain joint inch the base pan hole of outdoor unit, rotate: 90° to securely assemble them: Uninstall drain: joint as shown in Fig.B, insert the-drain joint into the base:panholeof outdoor unit until it is-secured; indicated with a:clicking sound.
NOTE: Connective pipe length: will affect the'capacity and energy efficiency of the unit: The nominal efficiency tested based on the pipe length of 24.561. LAl purging The indoor unit and tubing between the indoor amid outdoor Unit must be leak tested and evacuated tremor any trash and moisture from the system: 8 Check that each betroth liquid and gas side tubes) between the indoor and outdoorsy have Been properly connected and all wiring for the test runlets been complicated.
ING AND TEST forgo unit. 7. Remove the charge has firm the Low pressure charge hose, ) check point 8. Fully open the packed valve stems Band A. 9. Securely tighten the cap of the packed valve, safety and leakage check 1. Soap water method: Apply salsa water or a liquid neutral detergent of the fiddle Outdoor unit check point Grit connections arid authoritarian corrections using a soft brush toothache for leakage interconnecting points of the piping.
cooler COMFORT MADE SIMPLE Oasis Product design and specifications. are subject to change without prior notification. Contact the original seller or the product manufacturer for additional details: 202000192632 20131022 For more details visit www.
Before starting up; read this manual carefully and keep it for future reference, INVERTER SPLIT-TYPE ROOM AIR CONDITIONER HEAT PUMP INSTALLATION MANUAL (18K & 24K MODELS) ro.
INSTALLATION PRECAUTIONS @ Please read this installation manual carefully before operating the unit to ensure correct installation: @ Weatherstrip cord is damaged, replacement workaholic be performed by authorized personnel ably. & Installation must be parformedinaccordance with the requirement of NEC and CEC by authorized personnel early, & Contact an authorized service technician for repair, maintenance and installation of this unit.
Electrical work Electricity regulations forth initial Installation 1. If there are serious: safety problematical the power supply, the technicians] shoulder to install the air-conditioner until the problem is solved. 2. Power voltage should ban the range of of rated voltage: 3. Quintilian Must be properly grounded. Any disconnect and all other composition the power supply circuit should big bated for no less than 1.5 tines the equipment rating. 4.
Connective Pipe installation, 1. Fortieth-hand and right-land piping. remove the pipe cover firm topside panel. 2. Fortieth fight Back and deft back piping, install the piping 8s Shawn.
DRAIN JOINT INSTALLATION The'drain joint may differ depending oh the outdoor unit. For the drain joint with the first fit the:seal hitherto drain joint, then insert the drain joint into the base pan hole of bur door unit, rotate 90° to securely assemble them. To install drain joint as:shown Fig:B, insert the drain joint into the base pinhole of outdasrunituntl it is secured; indicated with a-clicking sound.
AIR PURGING AND TEST OPERATION NOTE: Connective pipe length will affect the capacity and energy efficiency of the unit. The grooming efficiency is tested basing on the pipe length of 24,5 1. Air purging @ The indoor unit and tubing between the indoor and outdoor unit:must be leak tested and evacuated to remove any handstand moisture from the system.
AIR PURGING AND TEST OPERATION B. Fully open the packed valve:stems B and A. 9. Securely tighten the cap of the packed valve. Cover 3. Safetyand leakage check 1. Sap water method: Apply a seawater ora liquid neutral detergent on the indoor unit connections and outdoor unit connections using a soft busty tw check for leakage of the connecting paints of the piping. lf bubbles come out; it indicates that the stovepipe leakage, 2. Leak detector: se the leak detector toc heck breakage.
cooler COMFORT MADE SIMPLE Oasis Product design and specifications. are subject to change without prior notification.