User's Manual

If the pattern needs any adjustment, the pattern size is adjusted via the Motion Range
Pot. Pattern position to the door is adjusted by physically moving the antenna in or
out (vertical tilt) and left to right (lateral tilt) as shown (F). Factory settings are ?˚
vertical tilt and 0˚lateral tilt.
Notice w/symbol: The threshold safety (presence detection) will not operate at this point.
Only the motion detection capabilities are functioning.
7. When desired pattern is achieved, remove power from the sensor.
Sensor Learn Mode: With Threshold Safety ON (Dip Switch #6=1)
During the sensor learn mode the door’s movement will be learned and the threshold
safety (presence) pattern will be created and adjusted to desired size. Upon power up, the
sensor will open and close the door two times. This allows the microprocessor to first
learn the door’s movements so that they can be ignored during normal operation and to
then create the threshold safety zone.
Warning w/symbol: Read this entire section before proceeding.
1. Clear any people and all temporary objects out of the detection pattern area.
2. Re-apply power to the sensor. The LED will flash ORANGE for 10 seconds
allowing time to clear the detection pattern area and then turn solid RED.
3. The door will open for 10 seconds. The LED will then turn solid GREEN and the
door will close for 10 seconds.
4. The open/close cycle is repeated a second time to verify readings.
5. Once sensor learn mode is complete the LED will flash GREEN for 10 seconds
and then become solid GREEN indicating a successful learn mode is complete and
the sensor is ready for normal operation.
6. Walk test the threshold safety pattern by approaching the door slowly from one
side and cross to the other while keeping your back against the door frame as
shown (K). The LED will flash RED when it detects you.
(K) Threshold Safety Zone Walk Test
Change the pattern size, if necessary, by adjusting the Threshold Safety
Pot (F).
7. Set the Relay Hold Time for desired setting via the Relay Hold Time Pot (F).
This is the amount of time the door will stay open after the sensor no longer
detects a person. The hold time can be set between 0-5 seconds. Factory Setting
is?
8. Replace the cover by engaging the left side first and then gently snapping the
cover into place as shown (J)
Notice w/symbol: Repeat walk test. If pattern size changes are desired remove the cover
from the right side and make the necessary adjustments (F).