User's Manual

8701 Castle Park Drive  Indianapolis, Indiana 46256
Telephone: [phone]  www.mssedco.com  [e-mail]
Page 4
S-CORv0312
Ratchet Relay – If Ratchet Relay is turned on, the output 2
relay will remain closed until a second signal is received.
HH Signal Range – ClearPath Spectrum devices transmit a
much greater distance than other wireless products used
in the automatic door industry. Since a hand-held trans-
mitter is paired with multiple coordinators in a building, or
with two buildings in closer proximity, the default HH
Signal Range is set to Reduced, requiring a very strong
signal for the hand-held transceiver to operate. If a hand-
held transceiver will not be used with used with any open-
ings nearby, the range can be expanded to “Normal” by
using the arrow keys and pressing Select when Normal
displays on the screen.
UnPair Devices – Transmitters can be unpaired by type, a
single device (requiring the PAIR button to be pushed on
that device to unpair, or All Devices, which will unpair the
coordinator from all transmitters.
Section 6
Operational Mode
The coordinator will display information upon receiving an
activation signal, including the ID, battery status of the
transmitter, and output relay status.
NOTICE: This device complies with Part 15 of the
FCC rules. Operation of this device is subject to the
following two conditions: 1) This device may not cause
harmful interference and 2) This device must accept
any interference received, including interference that
may cause undesired operation. Any changes or
modifications not expressly approved by MS SEDCO
could void the user's authority to operate this
equipment.
Spectrum Coordinator INSTALLATION INSTRUCTIONS
S-COR
hClearPat
™
Typical Installation Diagram
INSIDE TRANSCEIVER
EXTERIOR
INTERIOR



VESTIBULE
TRANSCEIVER
(OPTIONAL)
VESTIBULE SLAVE COORDINATOR
VESTIBULE MASTER COORDINATOR
OUTSIDE TRANSCEIVER
!