User's Manual

8701 Castle Park Drive  Indianapolis, Indiana 46256
Telephone: [phone]  www.mssedco.com  [e-mail]
Page 2
S-TRXv0312
6) Attach the mounting box frame to the back plate
already mounted in its intended location (step 1) by
placing the lock lip of the frame over the top of the
back plate, pushing it down in a hinge-like motion
(Fig.1).
7) Secure the mounting box frame to its back plate at
the underside with the 1/4-20 screw supplied (Fig.1).
NOTICE: This device complies with Part 15 of the
FCC rules. Operation of this device is subject to the
following two conditions: 1) This device may not cause
harmful interference and 2) This device must accept
any interference received, including interference that
may cause undesired operation. Any changes or
modifications not expressly approved by MS SEDCO
could void the user's authority to operate this
equipment.
Section 3
Maintenance
For best results, change the battery every 3 years, or as
needed. To remove the current battery, use a small
flat-head screwdriver, approaching from the PAIR button
side of the pcb as shown (See Fig. 4).
FIGURE 4
Transmitter Circuit Board
!
S-TRX (-R4, -R6, -J)
Spectrum Transceiver with Surface Mouting Box INSTALLATION INSTRUCTIONS
hClearPat
™
Battery 1
PAIR
Remove battery from this side.