User's Instructions

<<image if
applicable>>
(8) Connect the 10’ USB cable to the USB C port on the back of the io1 hook.
<<image if
applicable>>
(9) Route the cable back to the right cabin pillar and secure it in the upper corner near the roof leaving
some slack in the cable as shown.
NOTE: Use the provided cable ties and peel and stick cable tie mounts as needed.
<<image if
applicable>>
(10) Route the USB cable down along the pillar and display post as needed to control the wire path and
prevent it from interfering with other components.
NOTE: Use the provided cable ties and peel and stick cable tie mounts as needed.
<<image if
applicable>>
(11) Pass the cable down into the open access area and pull all slack cable through to the access area
to easily reach the already attached power pack.
<<image if
applicable>>
(12) Connect the USB type A end of the USB cord to the open port on the power pack.
NOTE: Look for the charge LED near the USB-C port on the hook to light either red or green to
confirm connection.
<<image if
applicable>>
(13) Route the USB cable from the power pack back along the control wall and to the entry point into
the access compartment.
NOTE: Use the provided cable ties and peel and stick cable tie mounts as needed to control the
wire path and prevent it from interfering with other components.
<<image if
applicable>>
(14) Coil any excess wire inside the access area.
NOTE: Use cable ties to secure it so that it does not interfere with any other components or the closing
of the access door.
<<image if
applicable>>
(15) Disconnect the USB cable from the hook.
<<image if
applicable>>
(16) With the magnetic clip base attached to the end of the USB cable, select a location near the right
pillar to af¬ix the magnetic clip base.
NOTE: This location should be easy for the worker to reach and not allow the stowed cable to
interfere with typical picking actions.
NOTE: Wipe the surface clean of grease, dust, debris, or other surface contaminants that may
affect adherence of the magnetic clip base.
<<image if
applicable>>
(17) Peel the paper off the magnetic clip base and firmly stick the base to this area.
<<image if
applicable>>
(18) Reconnect the PIT electrical system to the battery.
NOTE: Be sure power reaches the power pack by looking for the charging lights on the pack.
<<image if
applicable>>
(19) Replace the access panel(s) over the control area.
10 V-TEC io1 Smart Hook PFL
4 Installation US