User's Instructions

2 Description
• The V-TEC io1 consists of a V-TEC PFL and a permanently integrated Smart Hook component on the snaphook that
monitors and communicates connection status between the snaphook and a “tagged’ harness.
• Motion wakes the V-TEC io1 from sleep mode. During wake-up, an initial alarm sound beeps once to give the initial
reminder to connect.
• If a connection is present when awake, the V-TEC io1 will pulse a single green LED indicating good connection.
• During a connection event, a tri-beep is played to signal connection. No alarms are sounded during the connected period.
During a disconnection event, a tri-beep is played to signal disconnection.
• If a connection is not present when awake, the V-TEC io1 will “count down” a timer and eventually go into alarm sequence,
beeping 90 dB alarm sounds and blinking red lights.
Scenario 1: After waking, the hook goes into alarm in 15 seconds if no connections are found.
Scenario 2: After disconnection from the harness, the hook alarms after 30 seconds if no new connections are found.
• Motion sensors within hook allow it to fall asleep when no motion is felt.
• The units are calibrated to fall asleep when no movement being sensed. This allows the hook to fall asleep naturally when it
should, such as an order picker stepping off and leaving the hook to rest.
• Reference the V-TEC PFL manual, P/N 63011-98EN, included in the box, for additional information about the Personal Fall
Limiter and Fall Protection Connector Safety.
2.1 Physical Contents
Components Part Number
V-TEC io1 Smart Hook PFL
Charging Line Components
includes battery, wires, connector/adapter, cable ties, peel
and stick cable tie mounts
Carabiner
RFID Tag/Screws
V-TECPFLUser Instructions 63011-96EN-03
V-TEC io1 Smart Hook PFL User Instructions 10215637
6 V-TEC io1 Smart Hook PFL
2 Description US