User's Instructions

4 Installation
4.1 Installing the V-TEC io1
<<image if
applicable>>
(1) Disconnect power from the Powered Industrial Truck (PIT) electrical system.
<<image if
applicable>>
(2) Remove the access panel/s over the control area. Find the open power receptacle and clean as
needed.
<<image if
applicable>>
(3) Plug the input end of the power cord into the available power source. The white-striped wire of the
power cord is positive (+) and must be hardwired to a power source of 12-24 V. Use any leftover
cable clips and cable ties to manage access wires.
a) Confirm the supplied io1 system power connector will mate with the power receptacle. Each
PIT manufacturer has a slightly different preferred location. If unsure where to connect to a
hardwired power source on your truck, contact your local PITauthorized service center.
b) Ensure the connector is fully connectedand that there are no loose wires.
<<image if
applicable>>
(4) Clean the area of attachment for the auxiliary power pack. This should be a flat location on the
control wall where the auxiliary battery pack will fit.
WARNING!
Wipe away dust and dirt from the electrical leads with degreaser and a cloth
Failure to follow this warning can result in serious personal injury or death.
<<image if
applicable>>
(5) Mount the combined 24v to USB converter and power pack module to the face of the control wall
using the peel and stick foam panel.
Apply pressure to ensure a good adhesion is made. Use zip-ties to add physical restraint, if
possible and placement permits.
NOTE: If possible and placement permits, use zip-ties to add physical restraint.
WARNING!
Confirm this location has the required clearance between the control wall and the panel that will be placed over it.
Failure to follow this warning can result in serious personal injury or death.
<<image if
applicable>>
(6) Mount the V-TEC io1 system onto overhead fall protection rail.
<<image if
applicable>>
(7) Locate a place for the charging line holder on one of the overhead vertical slats that allows the
charging line to hang freely.
WARNING!
Hook must hang freely
Failure to follow this warning can result in serious personal injury or death.
V-TEC io1 Smart Hook PFL 9
US 4 Installation