Owners manual

2 INSTALLATION INSTRUCTIONS
MSD POWERSPORTS • WWW.MSDPOWERSPORTS.COM • [phone] • FAX [phone]
INSTALLATION OF THE VIEW SOFTWARE
DO NOT CONNECT THE UNIT TO YOUR PC PRIOR TO INSTALLING THE SOFTWARE!
1. Insert the installation CD Rom into the CD drive, wait up to 30 seconds, the CD will auto run, IF
THIS DOES NOT OCCUR:
Locate and open the CD Drive.
Double click on the Setup file.
2. Select “Click here to Install Version X.XX”.
3. Once loaded, your monitor will have an MSD View X.XX logo. Accept the agreement. Drive the
installation to your program files folder, press the enter key. The installation will complete, select OK.
4. A window will be opened with two aliases, double-click on the MSD View alias to launch the
software.
5. Connect the system controller via USB. If the software does not recognize the controller and
auto-connect, manually select the Blaster FI in the popup window and click Connect.
Note: MSD View can also be downloaded from www.MSDpowersports.com
SAVES AND TRANSFERS
Using the Blaster changes are in real time if the computer is linked to the ignition.
You can create and save numerous files on your PC and transfer them for testing purposes or to use
for various locations and conditions.
The following instructions will go through a general description of the use of the Blaster following the
tab system that you will see in the software.
INSTALLATION
The Blaster FI system is a piggy back system that will plug directly into the stock electronic system.
The unit can be placed on the side of the air box near the OE ECU mounting location.
1. Remove seat
2. Remove tail-light cover panel (bottom of bike)
3. Disconnect tail-light
4. Unplug stock ECU
5. Remove air box (Four bolts and the front clamp will loosen the box. Once the box is loose the
Crank Case Breather tube will be removed from the bottom.)
6. Remove stock ECU
7. Mount MSD Blaster FI unit using supplied mounting plate, supplied hardware, and some OE
hardware as depicted in Figure 1
8. Select initial tune
9. Replace air box
10. Plug Blaster in-line with OE ECU
11. For best results a small hole can be drilled in the tool box (just behind the air box) to mount the
OE ECU
12. Reassemble bike
Note: There is a second connector on this unit. It is for future features and is not used at this time.