Owners manual

2 INSTALLATION INSTRUCTIONS
MSD • WWW.MSDPERFORMANCE.COM • [phone] • FAX [phone]
Note: The ferrite pole pieces in the inductive
pickup are fragile and may be
damaged if the jaws are allowed to
"snap" closed or if the pickup itself
is dropped.
4. With the engine stopped, clean any dirt
from the timing marks. Figure 3 shows
several typical timing marks and the
rotation of the engine.
CHECKING THE ENGINE TIMING
Caution: When timing the engine, be very careful
not to let the Timing Light cables get
tangled in the engine's cooling fan.
1. Start the engine and let it warm up to operating
temperature. Note that the light flashes when the
power is connected. There is no trigger button.
2. Set the engine idle speed according to the
service manual using a tachometer.
3. If the distributor has breaker points, set the dwell
angle according to the service manual before
checking engine timing. (When using an MSD
Ignition, the dwell setting is not critical.)
4. With the engine idling at the recommended
rpm, aim the Timing Light at the timing marks.
The engine timing should be the same as
recommended in the service manual. If not, see
the next section on adjusting the timing.
ADJUSTING THE ENGINE TIMING
STANDARD POINTS OR ELECTRONIC DISTRIBUTORS
1. Stop the engine. Loosen the distributor hold-down clamp until the distributor is just loose enough
to turn the distributor by hand.
2. Restart the engine. Using the Timing Light, rotate the distributor until the timing marks line up.
Stop the engine and securely tighten the distributor hold-down clamp.
3. Restart the engine and recheck the timing. If the timing needs further adjustment, repeat.
CRANK TRIGGER SYSTEMS
1. Stop the engine. Loosen the timing pickup and adjust it in the bracket, depending on whether
you want to advance or retard the timing. Tighten the pickup.
Caution: Do not attempt to move the pickup while the engine is running. Personal injury or damage
to the timing pickup could result.
2. Restart the engine and recheck the timing. If the timing needs further adjustment, repeat step.
Figure 2 Inductive Pickup.
Figure 3 Typical Engine Timing Marks.
PLACE SPARK PLUG
WIRE IN THIS GA
P
INDUCTIVE PICKUP
NOTE: JAWS MUST CLOSE SO UPPER AND LOWER
POLE PIECES TOUCH EACH OTHER.
SPARK PLUG