Instruction manual

Chapter 3
3-18
SPP/EPP/ECP/ECP+EPP
To operate the onboard parallel port as Standard Parallel Port only,
choose “SPP.” To operate the onboard parallel port in the EPP mode
simultaneously, choose “EPP.” By choosing “ECP”, the onboard paral-
lel port will operate in ECP mode only. Choosing “ECP + EPP” will allow
the onboard parallel port to support both the ECP and EPP modes si-
multaneously.
EPP Mode Select
The onboard parallel port is EPP Spec. compliant, so after the user chooses the
onboard parallel port with the EPP function, the following message will be
displayed on the screen: “EPP Mode Select.” At this time either EPP 1.7 spec
or EPP 1.9 spec can be chosen.
ECP Mode Use DMA
The ECP mode has to use the DMA channel, so choose the onboard parallel
port with the ECP feature. After selecting it, the following message will appear:
“ECP Mode Use DMA.” At this time, the user can choose between DMA
channel 3 or 1.
Game Port Address/Midi Port Address
This setting assigns certain addresses for the game port and midi port.
Midi Port IRQ
This setting assigns an IRQ for the midi port.
Init Display First
This item specifies which VGA card is your primary graphics adapter. Settings:
PCI Slot and AGP.
AGP Auto Calibration
This setting disables/enables the AGP auto calibration. Setting options:
Disabled, Enabled.
IDE/USB1/USB0/Audio Access Interface
These settings control the access interface for specified hardware peripherals.
Setting options: (Auto), Embedded Bus, PCI Bus.
Kap3_6547v1.1.P65 05.02.02, 09:3418