User Manual
Table Of Contents
- Unpacking
- Safety Information
- Quick Start
- Specifications
- Block Diagram
- Rear I/O Panel
- Overview of Components
- CPU Socket
- DIMM Slots
- PCI_E1~5, PCI_1: PCIe/ PCI Expansion Slots
- M2_1~2: M.2 Slots (Key M)
- SATA1~6: SATA 6Gb/s Connectors
- JFP1, JFP2: Front Panel Connectors
- CPU_PWR1, ATX_PWR1: Power Connectors
- JCOM1: Serial Port Connector
- JUSB1~2: USB 2.0 Connectors
- JUSB3, JUSB4(optional): USB 3.1 Gen1 Connectors
- CPU_FAN1, PUMP_FAN1, SYS_FAN1~4: Fan Connectors
- JAUD1: Front Audio Connector
- JCI1: Chassis Intrusion Connector
- JTPM1: TPM Module Connector
- JBAT1: Clear CMOS (Reset BIOS) Jumper
- JLPT1: Parallel Port Connector
- EZ Debug LED
- BIOS Setup
- Software Description
- RAID Configuration (optional)
- Troubleshooting
- Regulatory Notices
47
BIOS Setup
f Intel(R) Thunderbolt [Fully Disabled]
fThunderbolt(TM) Support
Enables or disables Thunderbolt™ support.
f USB Configuration
Sets the onboard USB controller and device function. Press Enter to enter the sub-
menu.
fUSB Controller [Enabled]
Enables or disables all USB controller.
fXHCI Hand-off [Diasbled]
Enables or disables XHCI hand-off support for the operating system without XHCI
hand-off feature.
fLegacy USB Support [Enabled]
Sets Legacy USB function support.
[Auto] The system will automatically detect if any USB device is connected
and enable the legacy USB support.
[Enabled] Enable the USB support under legacy mode.
[Disabled] The USB devices will be unavailable under legacy mode.
fUSB Speed Optimization [Auto]
Enables or Disables the USB speed optimization. If set to Auto, BIOS will optimize
the USB speed automatically.
f Super IO Configuration
Sets system Super I/O chip parameters including LPT and COM ports. Press <Enter>
to enter the sub-menu.
fSerial (COM) Port x Configuration
Sets detailed configuration of serial(COM) port x. Press <Enter> to enter the sub-
menu.
fSerial (COM) Port x [Enabled]
Enables or disables serial (COM) port x.
fSerial (COM) Port x Settings [Auto]
Sets serial port x (COM). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.
fParallel (LPT) Port Configuration
Sets detailed configuration of parallel port (LPT). Press <Enter> to enter the sub-
menu.
fParallel (LPT) Port [Enabled]
Enables or disables parallel(LPT) port.
fParallel (LPT) Port Settings [Auto]
Sets parallel port (LPT). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.