Installation Guide

Using grout oat apply the grout on the tiles. Use vertical

and horizontal stroke to spread the grout. Apply a little

pressure to make sure that all the joints are well lled.

While the grout is still fresh, stroke diagonally the long

edge of the grout oat to remove excess grout and then

wipe it with wet sponge to clean.

Grouting and Final Cleaning:

Before applying grouts make sure that the adhesive is set and rm and the tiles are clean. Non-sanded

grout is the recommend grout to use for mosaic sheets due to small grout joints. Never use sanded grout

on polished glass mosaics this will scratch the material. Never use Epoxy grouts for the glass mosaic

tiles, unless specied by the manufacturer.

Cutting Mosaics Using Wet Saw:

When cutting mosaic on a wet saw, put a tile or a piece of hard plastic down on the cutting tray. This is

necessary to keep the mosaic from falling in the wide opening on the blade channel tray to be able to

make a good straight cut.

Once the grout is set and dry and if there is still residue use nylon brush to clean and then apply grout

sealer according to manufacturers instructions.