Operating instructions

Issue Date: 2003-09-25 Page 10 of 25 Report Reference # E203413-A17-CB-1
IEC 60950
SubClause Difference + Test Result - Remark Verdict
UL International Demko A/S
2.6.101 Addition:Earthing of CLASS 0I EQUIPMENT
Plugs with a lead wire for earthing not used for
equipment having a rated voltage exceeding 150 V
N/A
2.6.101 For plugs with a lead wire for earthing, the lead
wire is not earthed by a clip
N/A
2.6.101 CLASS 0I EQUIPMENT provided with an earthing
terminal or lead wire for earthing in the external
where easily visible
N/A
3.2.5 Delete the following statement from a note 1 in
Table 3B:
"For RATED CURRENT up to 3A, a nominal
cross-sectional area of 0.5 mm2 is permitted in
some countries provided that the length of the cord
does not exceed 2 m"
N/A
4.2.8 Add the following informative remark after the last
sentence:
"IEC 61965 is also applicable instead of IEC
60065"
N/A
4.5.1 Add the following to note 5) of Table 4A, Part 2:
"With regard to Table 4A, insulating materials
complying with Japanese requirements (refer to
Japanese differences for IEC 60335-1 3rd Edition
in CB Bulletin 101B) are also acceptable"
N/A
4.5.1 Add a note reference 7) to "50", in the right column
of Table 4A, Part 1 and add a note 7 to Table 4A,
Part 2 as follows:
"7) This value apply only to wiring or cords
complying with relevant IEC standards.
Others comply with Japanese requirements (refer
to Japanese differences for
IEC 60335-1 3rd Edition in CB Bulletin 101B)"
N/A
4.7.3.2 Add the following in 7th paragraph:
"- for thin materials, e.g., flexible printed boards,
etc., used inside equipment, be of FLAMMABILITY
CLASS VTM-2 or better"
N/A
5.1.6 Replace Table 5A to include maximum TOUCH
CURRENT values for CLASS 0I EQUIPMENT
N/A
5.3.8.2 Replace 3rd Item as follows:
"- BASIC INSULATION between the PRIMARY
CIRCUIT and accessible conductive parts of
CLASS I or 0I EQUIPMENT;"
N/A