Operating instructions

Issue Date: 2003-09-25 Page 20 of 25 Report Reference # E203413-A17-CB-1
IEC 60950
SubClause Difference + Test Result - Remark Verdict
UL International Demko A/S
3.2.1 Class II equipment provided with 15 or 20 A
standard supply outlets, Edison-base lampholders
or single pole disconnect device provided with a
polarized type attachment plug
N/A
3.2.3 Permanently connected equipment has provision
for connecting and securing a field wiring system
(i.e. conduit, or leads etc.) per the NEC and CEC,
Part 1
N/A
3.2.3 Permanently connected equipment may have
terminals or leads not smaller than No. 18 AWG
(0.82 mm²) and not less than 152 mm in length for
connection of field installed wiring
N/A
3.2.3 If supply wires exceed 60 °C, marking indicates
use of 75 °C or 90 °C wiring for supply connection
as appropriate
N/A
3.2.3 Equipment intended solely for installation in
Restricted Access Locations using low voltage d.c.
systems may not need provision for connecting and
securing a field wiring system. A method of
securing wiring or instructions must be provided to
ensure the wiring is protected from abuse
N/A
3.2.3 Equipment compatible with suitable trade sizes of
conduits and cables
N/A
3.2.5 Length of power supply cord 1.5 to 4.5 m unless
shorter length used when intended for a special
installation
N/A
3.2.5 Conductors in power supply cords sized according
to NEC and CEC, Part I
N/A
3.2.5 Power supply cords and cord sets incorporate
flexible cords suitable for the particular application
N/A
3.2.6 Strain relief provided for non-detachable
interconnecting cables not supplied by a limited
power source
N/A
3.2.9 Adequate wire bending space and volume of field
wiring compartment to properly make the field
connections
N/A
3.3 Field wiring terminals provided for interconnection
of units for other then LPS or Class 2 circuits also
comply with 3.3
N/A
3.3 Interconnection of units by LPS or Class 2
conductors may have field wiring connectors other
than those specified in 3.3 if wiring is reliably
separated
N/A