Operating instructions

Issue Date: 2003-09-25 Page 22 of 25 Report Reference # E203413-A17-CB-1
IEC 60950
SubClause Difference + Test Result - Remark Verdict
UL International Demko A/S
3.6 Equipment with earthed terminal (terminal for the
grounded conductor) of power source connected to
frame of the unit provided with special instructions
and provision for earthing
N/A
3.6 Equipment with means for connecting supply to
earthing electrode conductor has no switches or
protective devices between supply connection and
earthing electrode connection
N/A
3.6 Special markings and instructions for equipment
with provisions to connect earthed conductor of a
DC supply circuit to earthing conductor at the
equipment
N/A
3.6 Special markings and instructions for equipment
with earthed conductor of a DC supply circuit
connected to the earthing conductor at the
equipment
N/A
3.6 Terminals and leads provided for permanent
connection of DC powered equipment to supply
marked to indicate polarity if reverse polarity may
result in a hazard
N/A
4.2.8.1 Special opening restrictions for enclosures around
CRTs with face dimension of 160 mm or more
N/A
4.2.9 Compartment housing high-pressure lamp marked
to indicate risk of explosion
N/A
4.3.2 Loading test for equipment with handle(s) used to
support more than 9 kg tested at four times the
weight of the unit
N/A
4.3.6 In addition to the IEC requirements, Direct Plug-in
Equipment comply with UL 1310 or CSA 223
mechanical assembly requirements
Pass
4.3.12 The maximum quantity of flammable liquid stored
in equipment comply with ANSI/NFPA 30(Table
NAE. 7)
N/A
4.3.12 Equipment using replenishable liquids marked to
indicate type of liquid to be used
N/A
4.3.13 Equipment which produces x-radiation and does
not comply with 4.3.12 under all conditions of
servicing marked to indicate the presence of
radiation where readily visible
N/A
4.3.13 Requirements contained in the applicable national
codes and regulations apply to lasers (21 CFR
1040 and REDR C1370)
N/A