User Guide
Table Of Contents
- Quick Start
- Safety Information
- Specifications
- Package contents
- Block Diagram
- Rear I/O Panel
- Overview of Components
- Component Contents
- CPU Socket
- DIMM Slots
- PCI_E1~5: PCIe Expansion Slots
- M2_1~2: M.2 Slots (Key M)
- SATA1~6: SATA 6Gb/s Connectors
- CPU_PWR1~2, ATX_PWR1: Power Connectors
- JFP1, JFP2: Front Panel Connectors
- JUSBC1: USB 3.1 Gen2 Type-C Connector
- JUSB1~2: USB 3.1 Gen1 Connectors
- JUSB3~4: USB 2.0 Connectors
- CPU_FAN1, PUMP_FAN1, SYS_FAN1~5: Fan Connectors
- JAUD1: Front Audio Connector
- JCI1: Chassis Intrusion Connector
- JTPM1: TPM Module Connector
- JCOM1: Serial Port Connector
- JTBT1: Thunderbolt Add-on Card Connector
- JRGB1~2, JRAINBOW1: RGB LED connectors
- JCORSAIR1: CORSAIR Connector
- JBAT1: Clear CMOS (Reset BIOS) Jumper
- Onboard LEDs
- Installing OS, Drivers & Utilities
- MYSTIC LIGHT
- Nahimic 3
- BIOS Setup
- RAID Configuration
- Intel® Optane™ Memory Configuration
- Troubleshooting
44
Onboard LEDs
Onboard LEDs
EZ Debug LED
These LEDs indicate the debug status of the motherboard.
CPU - indicates CPU is not detected or fail.
DRAM - indicates DRAM is not detected or fail.
VGA - indicates GPU is not detected or fail.
BOOT - indicates the booting device is not detected
or fail.
DIMM LEDs
DIMM LEDs
These LED indicate the memory modules are installed.
XMP LED
This LED indicates the XMP (Extreme Memory Profile) mode is enabled.
XMP LED
JPWRLED1: LED power input
This connector is used by retailers to demonstrate onboard LED light effects.
JPWRLED1 - LED power input