User Guide
Table Of Contents
- Quick Start
- Safety Information
- Specifications
- Package contents
- Block Diagram
- Rear I/O Panel
- Overview of Components
- Component Contents
- CPU Socket
- DIMM Slots
- PCI_E1~5: PCIe Expansion Slots
- M2_1~2: M.2 Slots (Key M)
- SATA1~6: SATA 6Gb/s Connectors
- CPU_PWR1~2, ATX_PWR1: Power Connectors
- JFP1, JFP2: Front Panel Connectors
- JUSBC1: USB 3.1 Gen2 Type-C Connector
- JUSB1~2: USB 3.1 Gen1 Connectors
- JUSB3~4: USB 2.0 Connectors
- CPU_FAN1, PUMP_FAN1, SYS_FAN1~5: Fan Connectors
- JAUD1: Front Audio Connector
- JCI1: Chassis Intrusion Connector
- JTPM1: TPM Module Connector
- JCOM1: Serial Port Connector
- JTBT1: Thunderbolt Add-on Card Connector
- JRGB1~2, JRAINBOW1: RGB LED connectors
- JCORSAIR1: CORSAIR Connector
- JBAT1: Clear CMOS (Reset BIOS) Jumper
- Onboard LEDs
- Installing OS, Drivers & Utilities
- MYSTIC LIGHT
- Nahimic 3
- BIOS Setup
- RAID Configuration
- Intel® Optane™ Memory Configuration
- Troubleshooting
Rebuilding RAID Array
A RAID 1, RAID 5 or RAID 10 volume is reported as Degraded when one of its hard
drive members fails or is temporarily disconnected, and data mirroring is lost. As a
result, the system can only utilize the remaining functional hard drive member. To
re-establish data mirroring and restore data redundancy, refer to the procedure below
that corresponds to the current situation.
1. Power off.
2. Replace the failed hard drive with a new one that is of equal or greater capacity.
3. Reboot the system and go to BIOS > SETTING > Advanced > Intel(R) Rapid Storage
Technology.
4. Select the Degraded RAID volume from the Intel(R) Rapid Storage Technology
screen to enter the RAID VOLUME INFO screen.
5. Select the Rebuild item and press Enter key to rebuild the new hard drive.
80
RAID Configuration