Datasheet

Intel
®
815E Scalable Performance Board Development Kit Manual 19
Getting Started
— Connect the other end of the cable to the hard disk drive.
— Connect a power cable to the hard drive.
Caution: Make sure the tracer on the ribbon cable is aligned with pin 1 on both the hard disk and the IDE
connector header. Connecting the cable backwards can damage the evaluation board or the hard
disk.
7. Connect any additional storage devices to the evaluation board.
Note: The hard disk is already formatted and is pre-loaded with a customized target image of BlueCat
Linux by LynuxWorks.
8. Connect a Floppy drive (optional).
— Insert a floppy cable into FDC1 (be sure to orient pin 1 correctly).
— Connect the other end of the ribbon cable to the floppy drive.
— Connect a power cable to the floppy drive.
9. Connect the keyboard and mouse.
Connect a PS/2-style mouse and keyboard (see Figure 3 on page 32 for connector locations).
Note: U1 (on the baseboard) is a stacked PS/2 connector. The bottom connector is for the keyboard and
the top is for the mouse.
10. Connect the Ethernet adapter provided in your kit (optional).
11. Connect the audio speakers (optional).
For audio, connect the audio speakers to the on-board line out connector.
12. Connect the power supply.
Connect an ATX power supply to the evaluation board. Make sure the power supply is not
plugged into the wall (turned off). Insert the board connector of the power supply cord into the
ATXPR1 power supply header on the evaluation board. After connecting the power supply
board connector to the ATXPR1 header, plug the power supply cord into the wall.
13. Power up the board.
Power and reset are implemented on the evaluation board through jumpers located on PN1 and
PN2.
Power Jumper: The power jumper consists of pins 10 and 11 on PN1. (See Figure 5 on
page 46.) To power on the evaluation board, briefly short pins 10 and 11,
then, release the short. (To power off, short pins 10 and 11 for about five
seconds, until the power shuts off.)
Reset Jumper: The reset jumper consists of pins 1 and 2 on PN2. (See Figure 5 on
page 46.) To reset the evaluation board, short pins 1 and 2 until the board
resets, and then release the short.
Turn on the power to the monitor and evaluation board. Ensure that the fansink on the processor is
operating.