Instruction manual

3-13
BIOS Setup
SDRAM Burst Length
This setting allows you to set the size of Burst-Length for DRAM. Burst-
ing feature is a technique that DRAM itself predicts the address of the
next memory location to be accessed after the first address is accessed.
To use the feature, you need to define the burst length, which is the ac-
tual length of burst plus the starting address and allows internal address
counter to properly generate the next memory location. The bigger the
size, the faster the DRAM performance.
SDRAM 1T Command
This setting controls the SDRAM command rate. Selecting Enabled al-
lows SDRAM signal controller to run at 1T (T=clock cycles) rate. Se-
lecting Disabled makes SDRAM signal controller run at 2T rate. 1T is
faster than 2T.
Fast Command
This item controls the internal timing of CPU. Selecting Ultra allows
CPU to handle data/instructions at the fastest speed. Fast enables CPU
to handle at a faster speed, while Normal let CPU handle them at the
slowest rate.
AGP Timing Control
Press <Enter> and the following sub-menu appears.
AGP Mode
The item sets an appropriate mode for the installed AGP card. Setting
options: 1x, 2x, 4x, Auto. Select 4x only if your AGP card supports it.