User's Manual

BIOS Setup
3-21
These fields specify whether the system will be awakened from power
saving modes when activity or input signal of the specified hardware
peripheral or component is detected. Settings: Enabled, Disabled.
Note:
1. You need to install a modem card supporting power on function
for Wake Up On Ring function.
2. For Wake-Up Key function, the option Specific Key refers to
the password you specify in the Wake-Up Password field. You
must type the password to power on the system since the power
switch will not function any more after Specific Key is selected.
3. For Resume On PS/2 Mouse function, you need to DOUBLE
click the mouse to power on the system if the function is enabled.
Wake Up On PME
When setting to Enabled, the feature allows your system to be awakened
from the power saving modes through any event on PME (Power Man-
agement Event). Settings: Enabled, Disabled.
Resume By Alarm
This is used to enable or disable the feature of booting up the system on
a scheduled time/date from the soft off (S5) state. Settings: Enabled,
Disabled.
Alarm Date/Hour/Minute/Second
If Resume By Alarm is set to Enabled, the system will automatically
resume (boot up) on a specific date/hour/minute/second specified in
these fields. Available settings for each item are:
Alarm Date 01 ~ 31, Every Day
Alarm Hour 00 ~ 23
Alarm Minute 00 ~ 59
Alarm Second 00 ~ 59
Note: If you have changed this setting, you must let the system boot
up until it enters the operating system, before this function will
work.