Instruction manual

3-15
BIOS Setup
Onboard IEEE1394 Controller
This setting allows you to enable/disable the onboard IEEE 1394 controller. Set-
ting options: [Enabled], [Disabled].
AZALIA AUDIO
Select Enabled to use the audio capabilities of your system. Setting options:
[Auto], [Disabled].
MAC LAN
This setting controls the onboard LAN controller. Setting options: [Auto], [Disabled].
MAC LAN Bridge
This setting controls the onboard LAN bridge. Setting options: [Enabled], [Disabled].
MAC Media Interface
This setting controls the onboard LAN media interface. Setting options: [Pin
Setup], [MII], [RGMII].
I/O Devices Configuration
Press <Enter> to enter the sub-menu and the following screen appears:
Onboard Floppy Controller
Select [Enabled] if your system has a floppy disk controller (FDD) installed on the
system board and you wish to use it. If you install add-on FDC or the system has
no floppy drive, select [Disabled] in this field. The settings are: [Enabled],
[Disabled].
COM Port 1
Select an address and corresponding interrupt for Serial Port 1. Setting options:
[Disabled], [3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ4], [2E8/IRQ3].
IR Mode
This setting allows you to specify the operation mode for serial port 2. Setting
options: [Disabled], [IrDA], [ASKIR].
[Disabled] Disable RS-232C Serial Port
[IrDA] IrDA-compliant Serial Infrared Port
[ASK IR] Amplitude Shift Keyed Infrared Port
Parallel Port
This specifies the I/O port address and IRQ of the onboard parallel port. Setting
options: [378], [278], [3BC], [Disabled].