Instruction manual

2-4
KT3 Ultra-C ATX Mainboard
1. Please turn off the power and
unplug the power cord before
installing the CPU.
2. Pull the lever sideways away
from the socket. Make sure
to raise the lever up to a 90-
degree angle.
3. Look for the cut edge. The
cut edge should point towards
the lever pivot. The CPU can
only fit in the correct
orientation.
4. If the CPU is correctly
installed, the pins should be
completely embedded into the
socket and can not be seen.
Please note that any violation
of the correct installation pro-
cedures may cause permanent
damages to your mainboard.
5. Press the CPU down firmly
into the socket and close the
lever. As the CPU is likely to
move while the lever is being
closed, always close the lever
with your fingers pressing
tightly on top of the CPU to
make sure the CPU is prop-
erly and completely embed-
ded into the socket.
CPU Installation Procedures for Socket 462
Open Lever
Sliding
Plate
Cut edge
Close
Lever
Press down
the CPU
90 degree
Cut edge
Incorrect CPU placement
X
Cut edge
Correct CPU placement
O