Installation Guide
www.msistone.com
Installation of Mesh Mounted Flagstone
1. Surface Requirement
Mesh Flagstone is not design for Sand set installation.
free of sealants, grease and other oily compounds.
room. Measure the length and width of the room, marking
the halfway points.
• Dry lay the mesh in order to determine where the
mesh in the center of the room.
2. Setting the Flagstone
Spread the mortar out in an area that is slightly larger
than the size of one piece of Mesh Flagstone.
into mortar. Use a level or other straight edge to ensure
high points.
• It’s a good idea to wipe the stones clean as you set
wipe off the thin set.
3. Making a Template
• You will need to make cuts.
• Transfer the template onto the section of mesh that
newly cut mesh section gently in place.
4. Grout Installation
to the grout preparation guide on package. Fill
the grout with wet sponge; making sure no grout
5. Sealer (Optional)
• To protect your stone from stains and spills, we
recommended sealing the stone and grout.