Computer Computer Hardware User's Manual

3-14

MS-7031 Micro ATX Mainboard

SATA Device Configuration

Press <Enter> to enter the sub-menu and the following screen appears:

Onboard Serial ATA

This item is used to enable/disable the onboard Serial ATA controller. Setting options:

[Enabled], [Disabled].

Serial ATA Mode

This item is used to set the SATA configuration. Select [IDE] if you want to have SATA

as IDE function, and select [RAID] to use SATA as RAID function. Setting options:

[IDE], [RAID].

SATA Hotplug Support

This item is used to enable/disable the hotplug support. Setting options: [Enabled],

[Disabled].

I/O Device Configuration

Press <Enter> to enter the sub-menu and the following screen appears:

FDC Controller

Select [Enabled] if your system has a floppy disk controller (FDC) installed on the

system board and you wish to use it. If you install add-on FDC or the system has no

floppy drive, select [Disabled] in this field. Setting options: [Enabled], [Disabled].

COM Port

Select an address and corresponding interrupt for the first serial port. Setting options:

[3F8/IRQ4], [2E8/IRQ3], [3E8/IRQ4], [2F8/IRQ3], [Disabled], [Auto].

Parallel Port

There is a built-in parallel port on the on-board Super I/O chipset that provides Standard,

ECP, and EPP features. It has the following options:

[Disabled]

[3BC/IRQ7] Line Printer port 0

[278/IRQ5] Line Printer port 2

[378/IRQ7] Line Printer port 1