Instruction manual

Chapter 3
3-10
for error detection and correction when data passes through L2 cache
memory. Settings: Enabled and Disabled.
Processor Number Feature
This feature is for Pentium
®
!!! only. When set to Enabled, the system will
check CPU Serial Number. Set to Disabled if you don’t want the system to
know the CPU Serial Number.
Quick Power On Self Test
Setting the item to Enabled allows the system to shorten boot time since it
will skip some check items. Settings: Enabled and Disabled.
First/Second/Third Boot Device
The items allow you to set the sequence of boot devices where BIOS
attempts to load the disk operating system. The settings are:
Floppy The system will boot from floppy drive.
LS120 The system will boot from LS-120 drive.
HDD-0 The system will boot from the first HDD.
SCSI The system will boot from the SCSI.
CDROM The system will boot from the CD-ROM.
HDD-1 The system will boot from the second HDD.
HDD-2 The system will boot from the third HDD.
HDD-3 The system will boot from the fourth HDD.
ZIP The system will boot from ATAPI ZIP drive.
LAN The system will boot from the Network drive.
Disabled Disable this sequence.
Boot Other Device
Setting the option to Enabled allows the system to try to boot from other
device if the system fails to boot from the 1st/2nd/3rd boot device.
Swap Floppy Drive
Setting to Enabled will swap floppy drives A: and B:.
Boot Up Floppy Seek
This setting causes the BIOS to search for floppy disk drives at boot time.
When enabled, the BIOS will activate the floppy disk drives during boot