Instruction manual

3-12
MS-7058 ATX Mainboard
I/O Devices Configuration
Press <Enter> to enter the sub-menu and the following screen appears:
OnBoard Floppy Controller
Select [Enabled] if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it.
COM Port 1
This item specifies the base I/O port addresses of the onboard Serial Port 1 (COM A).
Selecting [Auto] allows AMIBIOS to automatically determine the correct base I/O port
address. Settings: [3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ4], [2E8/IRQ3] and [Disabled].
SATA Devices Configuration
Press <Enter> to enter the sub-menu and the following screen appears:
Option Description
[Enabled] Enables the onboard Floppy controller.
[Disabled] Disables the onboard Floppy controller.
ATA/IDE Configuration, Configure SATA as
These 2 items allow you to select the ATA/IDE and SATA configuration. Select [Disabled]
in ATA/IDE Configuration if you want to disable both ATA/IDE configuration. Select
[Compatible] or [Enhanced] to use the IDE, S-ATA and P-ATA devices. Refer to the
following tables for details.
ATA/IDE Configuration
(Compatible)
SATA Only [SATA 1/3/2/4]
PATA Pri, SATA Sec [IDE1, SATA2/4]
SATA Pri, PATA Sec [SATA1/3, IDE1]
PATA Only [IDE1]